Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 64
Search took 0.02 seconds.
Search: Posts Made By: john90290
Forum: Tech Help 01-01-2010, 02:13 PM
Replies: 5
Views: 1,631
Posted By john90290
This might be it....

My concern is a technical bulletin I found http://www.europeantransmissions.com...merc/97-20.pdf

from another post i just found. I for sure have the chatter in revere in the morning then no...
Forum: Tech Help 01-01-2010, 02:05 PM
Replies: 5
Views: 1,631
Posted By john90290
1994 e320 no reverse after she warms up...

I checked the fluid on the dipstick but to be honest, not really sure how to read the amount. I assume one side is for checking warm and one side for cold? anyway...followed the owners manual and it...
Forum: Tech Help 12-26-2009, 01:59 PM
Replies: 6
Views: 712
Posted By john90290
FEBI

I got the seal at fastlane from the link above...Great fit.
Forum: Tech Help 12-22-2009, 11:43 PM
Replies: 4
Views: 720
Posted By john90290
I believe there is a vacuum pump for the door...

I believe there is a vacuum pump for the door locks...like 50 bucks.
...
Forum: Tech Help 12-22-2009, 11:38 PM
Replies: 6
Views: 712
Posted By john90290
FEBI

Got the febi seal and it even looks like it will fit better. Not sure I follow where the glue should be place? I am assuming the strap is the metal latch between the hinges I remove in order to fit...
Forum: Tech Help 12-21-2009, 11:37 AM
Replies: 6
Views: 712
Posted By john90290
Ebay door seals stink...

1994 e320 139k

Purchased a door seal for the front driver's side from eBay to save a few dollars...it's a horrible fit. Purchased one from Fastlane so I get to embark on the entire process once...
Forum: Tech Help 05-18-2009, 10:45 PM
Replies: 6
Views: 1,303
Posted By john90290
Where is the auxilliary water pump located w124

heat on all the time and want to test the voltage from the auxilliary water pump but the information below does not state where to find the pump.

Any help would be appreciated.
Forum: Tech Help 12-04-2008, 10:16 PM
Replies: 1
Views: 418
Posted By john90290
w124 e320 1994 Brake Clanking....

Whenever I first take off for work in the morning, at the very first stop with any kind of momentum, I hear a clank on the left and then one on the right coming from the wheels. It's like a hammer...
Forum: Tech Help 11-07-2008, 12:43 AM
Replies: 3
Views: 728
Posted By john90290
Thanks guys, it was the brake heat shield. I...

Thanks guys, it was the brake heat shield. I guess while I was trying to get the sway bar out I banged up the heat shield.

Thanks again.

-John
Forum: Tech Help 11-04-2008, 12:44 PM
Replies: 3
Views: 728
Posted By john90290
e320 w124 rear sway bar grinding noise help please

1994 E320 Sedan

I changed the rear sway bar per the instructions found on the w124 manuals on CD. I've done this before on a 1988 e300 so I had some experience with this total pain in the butt...
Forum: Tech Help 03-06-2008, 12:39 PM
Replies: 0
Views: 484
Posted By john90290
1994 e320 rear swaybar...rocket science?

I took my e320 in to have the rear sway bar (a 500e upgrade) put in as i've done it before on my 1989 and didn'tt have much fun doing it.

My mechanic says that it's a 3 hour job to remove and...
Forum: Tech Help 02-26-2008, 06:08 PM
Replies: 3
Views: 981
Posted By john90290
Will check it tonight. If it does not, then...

Will check it tonight. If it does not, then what's the solution?

Thanks again for the quick response.
Forum: Tech Help 02-26-2008, 06:00 PM
Replies: 3
Views: 981
Posted By john90290
1994 e320 w124 code 26

She threw a #26 the other day. I reset and it has yet to come back. I've since replaced the neutral saftey switch, not sure if that was the culprut?

I've searched and discovered that it has to...
Forum: Tech Help 02-23-2008, 01:50 PM
Replies: 24
Views: 2,316
Posted By john90290
I rolled it up on ramps, blocked both rear tires...

I rolled it up on ramps, blocked both rear tires and started the process of removing the linkage first (oh, unplug the connector first, unlock the white ring clockwise or "up" as you are laying on...
Forum: Tech Help 02-23-2008, 01:52 AM
Replies: 24
Views: 2,316
Posted By john90290
done deal!

replaced the switch, thanks for the help guys. As usual, it took twice as long as I thought. I was not really difficult just hard to get to. (I don't think removing the pan would have helped btw.)
...
Forum: Tech Help 02-15-2008, 12:06 PM
Replies: 24
Views: 2,316
Posted By john90290
1994 E320 Neutral Saftey Switch installation help request.

I have the new switch and was planning on installing it this weekend...the only problem is that I cannot find any details about the switch in my CD-ROM manuals.

Any suggestions as to which module...
Forum: Tech Help 02-05-2008, 01:38 PM
Replies: 7
Views: 935
Posted By john90290
I just moved so I could not find my LED tool so i...

I just moved so I could not find my LED tool so i had to build another one.

I'll have to check codes tonight.

In the meantime I replaced the MAS and the car runs like new, unreal. I want to...
Forum: Tech Help 02-04-2008, 08:30 PM
Replies: 7
Views: 935
Posted By john90290
Ok, I was looking at the data link connector not...

Ok, I was looking at the data link connector not the diagnostic connector....I'll run the checks again tonight and get back to you....
Forum: Tech Help 02-04-2008, 06:37 PM
Replies: 11
Views: 3,020
Posted By john90290
Check for my posts as well, I have some pictures...

Check for my posts as well, I have some pictures included from when I did the job. john90290 is the user name.

You must replace the bolts as they are a one time use item.

Good luck! Take your...
Forum: Tech Help 02-04-2008, 06:23 PM
Replies: 7
Views: 935
Posted By john90290
I am going to check the codes and the pressure...

I am going to check the codes and the pressure regulator tonight. Some good leads, I'll report back tomorrow.

Out of curiosity, how can I check pin #3? Isn't that the power supply for the code...
Forum: Tech Help 02-04-2008, 03:31 PM
Replies: 7
Views: 935
Posted By john90290
w124 1994 looping idle, sometimes....

Problem: A 1994 e320 with a looping idle on occasion. Loops from the 700 to the 1200 range a half dozen times before settling down (note, only in park or in neutral).

The check engine light came...
Forum: Tech Help 12-21-2007, 01:01 PM
Replies: 1
Views: 455
Posted By john90290
e320 O2 replacement - strange strap?

I replaced my o2 sensor on my 1994 e320, no problem but there was this braided ground type strap that was attached to the o2 sensor with a hose clamp and then to the body. I attached a picture of...
Forum: Tech Help 12-19-2007, 01:09 PM
Replies: 3
Views: 935
Posted By john90290
Makes sense. Thanks for the quick response and...

Makes sense. Thanks for the quick response and the part reference.

-John
Forum: Tech Help 12-19-2007, 07:45 AM
Replies: 3
Views: 935
Posted By john90290
1994 e320 ECT Sensor location

anyone know where this is located in the engine bay and the replacement part number?

thanks much,

john
Forum: Tech Help 07-15-2005, 07:38 PM
Replies: 4
Views: 990
Posted By john90290
300e 124 idle...solved it!!!!!!!!!

I've read all the posts on this site...i replace fuel injector relays, OVP, tune ups, actual fuel injectors...you name it. I replaced one freak'n motor mount on the passager side, no idle problems at...
Forum: Tech Help 06-29-2004, 12:20 PM
Replies: 3
Views: 976
Posted By john90290
Nope, straight out of the box. When i first...

Nope, straight out of the box. When i first started the car I turned the key, let the fuel pump run and cranked for about 20-30 seconds and it was off to the races. No problems since then. Just...
Forum: Tech Help 06-28-2004, 05:25 PM
Replies: 3
Views: 976
Posted By john90290
Unhappy Thanks for the help.

I would like to say thanks for all of the technical support with regard to my question. In the words of Al Pacino in the movie "heat" I am over-blanking-whelmed.

Too bad, you guys have helped me...
Forum: Tech Help 06-24-2004, 05:23 PM
Replies: 3
Views: 976
Posted By john90290
Question 300e Step by Step Fuel Injector R/R is this correct?

After a search of the 300E idle problem links on this site and replacement of some of the common ailments (OVP, Fuel Pump Relay, Vacuum Hoses, Coil....etc.) I am making the relatively small...
Forum: Tech Help 12-20-2003, 12:30 PM
Replies: 0
Views: 622
Posted By john90290
Question 1989 300e ext. molding.

1989 300e, the molding fell off on a couple of sections. (It is not the big panel type molding as on the later 300e's) I repaired the section on the door by removing the door panel and undoing the...
Forum: Mercedes-Benz Performance Paddock 06-04-2003, 02:36 PM
Replies: 6
Views: 1,266
Posted By john90290
Thanks

That's great information. I will give it a shot next weekend. Thanks again!

John
Showing results 1 to 30 of 64

 
Forum Jump


All times are GMT -4. The time now is 09:16 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page