Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 34
Search took 0.02 seconds.
Search: Posts Made By: iread
Forum: Mercedes-Benz Used Parts For Sale & Wanted 08-19-2012, 11:00 PM
Replies: 8
Views: 818
Posted By iread
I'm looking for a ZS hydraulic line from the...

I'm looking for a ZS hydraulic line from the control valve to the transfer case for a 90-93 W124 4matic.

This is the 8mm line with 14mm hex fittings.

PN 124 350 08 80
Thanks,
Ian
Forum: Mercedes-Benz Used Parts For Sale & Wanted 05-26-2011, 11:29 PM
Replies: 16
Views: 1,057
Posted By iread
I also have a M103 stalling problem which occurs...

I also have a M103 stalling problem which occurs only when I let the car sit for more than two days. If driven daily it never fails to serve. Usually after sitting for 2+ days it starts fine then...
Forum: Tech Help 10-18-2008, 12:01 AM
Replies: 19
Views: 1,614
Posted By iread
Two blinks is supposed to mean that the control...

Two blinks is supposed to mean that the control unit is faulty but I have not heard anyone ever having one replaced. There are two switches in the system, one pressure switch at the tranfer case and...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 09-18-2008, 01:46 AM
Replies: 3
Views: 550
Posted By iread
I need a front right lower control arm eccentric...

I need a front right lower control arm eccentric bolt/pin from the aft bushing, not the front bushing. Either the left or right side bolt would work.
I agree, if you can you should part out some...
Forum: Tech Help 08-11-2005, 01:56 PM
Replies: 5
Views: 731
Posted By iread
Rob, The first Blaupunkt had a bad CD...

Rob,

The first Blaupunkt had a bad CD mechanism, the second unit likely worked fine but the wire short probably affected its operation when the wire was connected. Both units I returned to the...
Forum: Tech Help 08-11-2005, 01:41 AM
Replies: 5
Views: 731
Posted By iread
Angry Today's MB Customer Service

In mid June I had my 1990 300TE in of a bodyshop for some minor passenger door bodywork due to a friend backing into it incident.
I took it to our local MB Canada (Richmond) bodyshop because I...
Forum: Car Audio and Multimedia 07-19-2005, 12:01 AM
Replies: 5
Views: 1,023
Posted By iread
Steve, I think I have the Becker 1480, but...

Steve,

I think I have the Becker 1480, but I'm not sure, it just says Mercedes Benz across the front.
Unfortunately no amp at the antenna location. My April built TE is not a late model 1990,...
Forum: Car Audio and Multimedia 07-16-2005, 01:47 PM
Replies: 5
Views: 1,023
Posted By iread
thanks Ray but the 90 does not have the rear amp,...

thanks Ray but the 90 does not have the rear amp, that amp appeared in 91.
Forum: Car Audio and Multimedia 07-16-2005, 01:23 AM
Replies: 5
Views: 1,023
Posted By iread
1990 300TE MB Becker Deck squeeling

Yesterday my OE Mercedes (Becker) cassette/radio started squeeling through the speakers and will not stop. Other functions are as normal. Bad solder joint or worse condition?
Forum: Tech Help 11-17-2003, 05:18 PM
Replies: 5
Views: 1,588
Posted By iread
John, Yes, I have changed the fluid. It...

John,

Yes, I have changed the fluid. It takes approx. 700ml of Dextron, preferably Mobil 1 synthetic ATF. I try to do this every 15,000km, I think the 4matic manual states a number above this. The...
Forum: Events & Gatherings 06-07-2003, 01:28 AM
Replies: 74
Views: 4,025
Posted By iread
Looks like I'm coming too. August 2 works for me.

Looks like I'm coming too. August 2 works for me.
Forum: Diesel Discussion 05-28-2003, 06:51 PM
Replies: 2
Views: 913
Posted By iread
I believe the 4matic has a slightly different...

I believe the 4matic has a slightly different block because of the front differential being integrated into a modified oil pan assy.
Forum: Tech Help 05-28-2003, 06:16 PM
Replies: 5
Views: 1,588
Posted By iread
To disable the 4MATIC on the 92/93 124's you...

To disable the 4MATIC on the 92/93 124's you switch an electrical Test lever under the hood (right side). The switch disables the hydraulic solenoids from actuating at the 4matic valve assy....
Forum: Mercedes-Benz Performance Paddock 01-11-2003, 02:18 AM
Replies: 11
Views: 2,672
Posted By iread
If you are going to compare a 124 4matic to a...

If you are going to compare a 124 4matic to a Audi Quattro. You may have to compare the 90-93 MY's. Which car would you rather drive?

I don't know much about Quattros except that the newer models...
Forum: Mercedes-Benz Cars For Sale 10-31-2002, 01:43 AM
Replies: 4
Views: 777
Posted By iread
Mateo, The TD 4matic was available only in...

Mateo,

The TD 4matic was available only in Europe. Only the 4maticTE and E versions were available in NA.
Forum: Tech Help 02-04-2002, 01:12 PM
Replies: 8
Views: 1,038
Posted By iread
The "old 4MATIC system" made available in North...

The "old 4MATIC system" made available in North America from 90 to 93 (from 88 in Europe) is a four mode system. It is not a really complex system but can be difficult/expensive to repair or...
Forum: Tech Help 01-27-2002, 02:41 AM
Replies: 8
Views: 1,664
Posted By iread
I have a 1990 TE 4MATIC and have had to replace...

I have a 1990 TE 4MATIC and have had to replace the transfercase (TC) due to the common internal hydraulic leak problem. But all in all I have been happy with the car in my 4 years of ownership. The...
Forum: Tech Help 06-24-2001, 12:33 AM
Replies: 1
Views: 497
Posted By iread
The aluminum servos are obtainable from: ...

The aluminum servos are obtainable from:

George Murphy

Performance Analysis Company
All MB parts plus
Climate Control & Electronics

1345 Oak Ridge Turnpike
PMB 258
Forum: Tech Help 06-21-2001, 04:23 PM
Replies: 3
Views: 638
Posted By iread
Bill, I have a 1990 TE $Matic and also the...

Bill,

I have a 1990 TE $Matic and also the 4MATIC service manual. It is detailed but does not contain any information on how to rebuild the transfer case, valve, pump or differentials. It does...
Forum: Mercedes-Benz Wheels & Tires 04-30-2001, 11:37 AM
Replies: 10
Views: 1,553
Posted By iread
I have some BFG Comp T/A VR4 on my 90 TE4Matic....

I have some BFG Comp T/A VR4 on my 90 TE4Matic. They show very little edge wear and are at 20Kmi now. I am pretty happy about these tires, they will probably run another 20Kmi. They are quiet running...
Forum: Tech Help 09-28-2000, 12:56 PM
Replies: 4
Views: 1,058
Posted By iread
Well in turns out that they charged me 12 hours...

Well in turns out that they charged me 12 hours of labour to R&R the transfer case, but gave me a 15% discount. They said that the transmission needed to come out (6.8 hours). So now the 4Matic...
Forum: Tech Help 09-21-2000, 01:13 PM
Replies: 4
Views: 1,058
Posted By iread
How long should it take a Mercedes Tech to R&R a...

How long should it take a Mercedes Tech to R&R a 4Matic transfer case in a 1990 300TE?
I am being charged for 10 hours at the local MB dealer. Is this reasonable? They installed a rebuilt transfer...
Forum: General Information 07-22-2000, 02:39 AM
Replies: 30
Views: 6,762
Posted By iread
I have the HAynes manual on the 124. It does...

I have the HAynes manual on the 124. It does cover the intake manifold R&R while in the car it is a short simple procedure. However it does cover the R&R of the cylinder head. It is a 4 page detailed...
Forum: Tech Help 07-11-2000, 03:28 AM
Replies: 1
Views: 1,683
Posted By iread
My car has approx. 85000 miles on it and have...

My car has approx. 85000 miles on it and have been leaking hydralic fluid from the transfer case for about the last 20k. Lately it has been losing aboout a quart every 400 miles. Not good, I'm...
Forum: Tech Help 03-09-2000, 01:10 AM
Replies: 18
Views: 4,830
Posted By iread
I took my car into the local MB dealer. They said...

I took my car into the local MB dealer. They said it is the MAS too. Also said that I need a A/C system tune up to R134. ($700). I think i'll call Cool-It. Problem is that it cools well and I've...
Forum: Tech Help 02-21-2000, 06:12 PM
Replies: 18
Views: 4,830
Posted By iread
Thanks, Joel, I'll try them. Jeff, to clarify...

Thanks, Joel, I'll try them.
Jeff, to clarify my problem, the A/C compressor was engaged on any Climate Control function setting, even 0 (OFF), until I disconnected the A/C pump connector.
I...
Forum: Tech Help 02-18-2000, 02:47 AM
Replies: 18
Views: 4,830
Posted By iread
Yes Jeff, the clutch engaged while I was driving,...

Yes Jeff, the clutch engaged while I was driving, I noticed it because of a whirring noise. It was below freezing out when this happened and I was on the ECON setting. The clutch then disengaged for...
Forum: Tech Help 02-15-2000, 03:33 PM
Replies: 18
Views: 4,830
Posted By iread
My A/C problem is back. Now the clutch is always...

My A/C problem is back. Now the clutch is always engaged on my '90 TE 124. The clutch was erractically chattering in and out but then locked in. I've disconnected the cable to the compressor,...
Forum: Tech Help 09-12-1999, 04:03 AM
Replies: 8
Views: 1,024
Posted By iread
The car is finally running again. Case closed. ...

The car is finally running again. Case closed.

------------------
Ian Read
90 300TE4MATIC (124)
79 300SD (116)
Forum: Tech Help 09-09-1999, 11:30 AM
Replies: 8
Views: 1,024
Posted By iread
Your copper comment noted. I still haven't...

Your copper comment noted. I still haven't finished the job. The new sleeve was machined wrong. The key notch was 90 degrees out of place, the car wouldn't start. And to make the job even more...
Showing results 1 to 30 of 34

 
Forum Jump


All times are GMT -4. The time now is 02:08 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page