560SL Alignment Specs

[Roncallo]

Does anyone have MB published wheel alignment specs for a 1986 560SL. They are not on the CD or Chassis service manual and I get conflicting data from all other sources. I now have the car aligned within Firestone specs but it sucks and pulls left.

[rocky raccoon]

Specs I used are in ALLDATADIY. I am at work and will send when I get home this evening. I will also check my mantenance CD also. They are not all the same.

[rocky raccoon]

for my 1988 560SL

NOTE Perform alignment measurements in "Ready to Drive" condition, (i.e., at normal road height with simulated passenger load).
Front Axle
Camber [1]

Wheels in straight ahead position -0°10' (+10', -20')Max difference between left and right 0°20'
Caster [1]

Wheels in straight ahead position 10°30' (+30', -30')Max difference between left and right 0°30'
Toe-In [1]

Wheels spread at front with 90-110 Nm 0°20' (+10', -10')
Track Difference [2]

Angle at 20°lock of wheel nearest curve -0°45' (+40', -40')[1] Tolerances for test only. Try for nominal value during adjustment.[2] Value indicated without toe-in.
Rear Axle

Camber:
Measure distance in height from inner semi-trailing arm mount to lower edge of wheel bearing carrier coupling. Camber reading for measured height should be as follows:

Height Spec: 130 0°±30'125 0°15' ±30'120 0°30' ±30'115 0°45' ±30'110 1°±30'105 1°15' ±30'100 1°30' ±30'95 1°45' ±30'Toe Total (inch): 0°25' ±15'

[Roncallo]

Excellent
Thank You