|
|
|
|
|
#1
10-07-2006, 07:15 PM
|
||||
|
||||
|
Brake fluid flush and ASR
'95 SL500. Will use Motive pressure bleeeder/flush unit. On my 95 E420 there was a bleeder connection on the ASR unit but my SL500 the ASR reservoir looks different, even though this is basically same engine, and I cannot see bleed valve.
Is this necessary if I use Motive pressure unit and just flush via the calipers? Or can anyone tell me where the ASR bleeder valves located? All I can see is the 4 brake lines plus another line(master cylinder line?) running to unit and no bleeder valve. Thanks
__________________
95 E420 ( 76K) SOLD 85 380SE(125k) 95 SL500(72k) 
|
|
#2
10-07-2006, 08:42 PM
|
|||
|
|||
|
I have always flushed mine from the reservoir using 20 psi, without a problem.
__________________
Chuck Taylor Falls Church VA '66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe
|
|
#3
10-07-2006, 08:47 PM
|
||||
|
||||
|
The valves are all normally open anyways, just flush out through the calipers like normal.
Gilly
__________________
Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold)
|
|
#4
10-08-2006, 08:04 AM
|
||||
|
||||
|
thank you, that's what I'll do.
__________________
95 E420 ( 76K) SOLD 85 380SE(125k) 95 SL500(72k)
|
 |
| Bookmarks |
|
|
Linear Mode
