|
|
|
#1
|
|||
|
|||
turn signals DON'T WORK (450sl)
I installed a radio and speakers, they work fine I did'nt disturb any lighting wires. I checked the Chiltons manual which directs you to blown fuse or bad turn signal flasher. Ilocated the hazard
flasher but not the turn signal flasher ,I also don't see any blown fuse. Can anyone help? |
#2
|
||||
|
||||
No problem I have done it twice to myself. Lift the back edge of the console slightly and you will probably find the hazard switch unpluged. Also I am preety sure that one flasher handles both duties.
__________________
Happy Benzing Darryl, Hill 2005 SL55 AMG Kleemanized 1984 500 SEC 1967 W113 California Coupe [SIGPIC] https://picasaweb.google.com/lh/myphotos Last edited by hill; 07-01-2002 at 02:02 AM. |
#3
|
|||
|
|||
Just turn the hazard flasher on/off a couple of times and see if this clears the problem. I've encountered the same thing when getting under the shifter and this has fixed it each time.
__________________
Don '85 500SL (Euro) - 186,000 w/a complete restoration and engine rebuild at 154,000 '95 C280 - 174,000 |
#4
|
|||
|
|||
It does sound like the hazard flasher. If you still need check the turn signal flasher though, it is right behind the instrument console. Remove the steering wheel, and the console will pop out when you pull it - it's only held in by a gasket. (Be careful of the oil pressure cable and speedometer cable). The turn signal flasher is toward the right/middle.
Good Luck.
__________________
Tjohn 82 300 SD 77 450 SL (gone) |
#5
|
|||
|
|||
turn signals don't work 450sl
Thanks Hill and Sublettd you were right I lifted the shifter cover and there it was not fully seated (hazard switch) Turn signals now working again. This is a great site ,probably saved me $100.00. thanks again
|
Bookmarks |
|
|