Is there a pattern or system for aiming the washer jets on the 560SL? I remember reading it once but I can't recall where I read it. I would appreciate any help on this. Thank you
|
Hi,
The specs are listed in the Maintenance Manual(group 82). I don't have the specifics for the W107 but it should be about the same for all of the cars. Basic adjustment for twin dual nozzles(without getting a meter-stick and a marker)is that the inner jets shoot about 40 mm higher than the outers. And the inner streams cross. Other than that, I just use a pin vise with a piece of stiff wire in it to aim them. Did that make any sense at all? Regards, Randy D. ------------------ W.R.Durrance ASE Master Tech Mercedes Tech 21 Years 68 250SE 68 SAAB 96 Ice Racer 69 300SEL 6.3 70 300SEL 3.5 81 300TDT W.R.Durrance Engineering |
Thank you for your help at least it's a starting point to experment with.
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by WDurrance: Hi, The specs are listed in the Maintenance Manual(group 82). I don't have the specifics for the W107 but it should be about the same for all of the cars. Basic adjustment for twin dual nozzles(without getting a meter-stick and a marker)is that the inner jets shoot about 40 mm higher than the outers. And the inner streams cross. Other than that, I just use a pin vise with a piece of stiff wire in it to aim them. Did that make any sense at all? Regards, Randy D. <HR></BLOCKQUOTE> |
All times are GMT -4. The time now is 12:12 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website