|
|
|
#1
|
|||
|
|||
I need to replace the rear bumper pad not the whole bumper, on a 1989 300E. I was wondering if anyone could help me out and tell me the steps which are requiered to do this before I start something which I might not be able to finish. Any help would be apreciated.
Mladen |
#2
|
|||
|
|||
If you are talking about the rear impact strip, here is the part number: 124-885-03-21
I have not yet done this but ordered this part recently. Let us know! |
#3
|
|||
|
|||
You will have to remove the plastic bumper shroud. The ends can be gotten from inside the trunk behind the trunk liner. The center retainer hardware can be removed from under the car. Be careful when removing the plastic shroud. It is large, wobbles around and in your case is 11+ years old (prone to breakage). The impact strip can be removed after you remove the plastic shroud. Good luck..
------------------ Jeff Lawrence 1989 300e 2000 Dodge Grand Caravan SE [This message has been edited by jeffsr (edited 11-01-2000).] |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Genuine Brand new Wald rear bumper for W210 | The Godfather | Mercedes-Benz Used Parts For Sale & Wanted | 0 | 12-13-2004 07:14 AM |
bumper pad | janko | Diesel Discussion | 1 | 11-19-2003 09:49 PM |
Rear Bumper (fell off) | floydo | Diesel Discussion | 12 | 04-06-2003 09:01 PM |
Replacing chrome bumper trim | Snibble | Off-Topic Discussion | 4 | 09-06-2002 08:47 PM |
Rear brake pad sensors? | DieselHead | Diesel Discussion | 7 | 02-02-2002 10:34 PM |