|
380 shift linkage bushings installation?
What is the trick to get the plastic bushing into the lever that connects the floor shifter to the rod that goes to the transmission?
|
Put it in hot (boiling even) water for a minute or so, fish it out (especially if you use boiling water) with a pair of needle-nose pliers and get it installed asap (as soon as you can touch it)
Gilly |
I tried a lot of things, and resorted to cutting it with a razor. They are holding up just fine. Don't forget to replace the one at the transmission. It will be just as brittle as the shifter one.
|
| All times are GMT -4. The time now is 02:10 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website