This is for a 1983 240D. I have been working on this for a while and have determined that the temperature gauge is bad (I am 98% sure it is the temp gauge). I have found an insturment cluster with a bad oil pressure gauge. I am trying to take the good temp gauge off one cluster and exchange it for the bad one on one the other cluster. I have tried to remove the needle off the good temp gauge and have encoutered some difficulty in getting it off. I know it just slides off, but I am afraid that I might damage the good gauge if I do this incorrectly. Is there a recommended way to get the needle off, or to I just try to be careful?
|
I would fabricate a small puller that will slide under the needle and then use it like a slide hammer to take it off.
------------------ Benzmac: Donnie Drummonds 300E ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM OWNER OF MB AUTOWERKS .COM |
All times are GMT -4. The time now is 03:44 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website