190 blower switch removal replacement
 

Im trying to replace the blower motor switch on my 1993 190e .,.

i took the two screws off under the wood panel..

i see the two screws on the bottom of the center vents too..

do i need to remove those screws to get to that blower switch.. i also see the two screws that hold the switch in place.. do i need to remove the entire push button assembly to replace the blower switch?? if so if anyone has done ths before i sure would appreciate
any ideas in how to get that switch and or unit out :confused:

thanks in advance@@

Im not sure how it is on a 93, but there should be 2 screws where the 2 top center vents are. Then 2 screws at the bottom center side vents. Im not sure if you have an ashtray or not. But theres 2 screws for that too. Then you should easily have access to the blower switch.

Repaired~
 

:sun_smile found a used switch on ebay 31 bux with shipping.,

took out all the screws, radio and the 6 cassete tape holders.

pulled out the push button unit.. unplugged bad swtich

replaced with the ebay switch and now i have my 4 speed blower motor back! :rolleyes:

put everything back together ... real cheap fix plus the aggrivation was PRICELESS!~
:pukeface:

local shop wanted 200 bux just for the switch not counting labor!