Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 03-16-2005, 06:12 PM
Registered User
 
Join Date: Mar 2005
Posts: 25
Steering Gearbox slop?

85 300SD - how much slop in the gearbox is too much? Is there a good source for used parts, I noticed that I new one is about $600-$700. Also when I had BigO tires rotate and balance the tires, they noted that there was excessive play in the tie rod ends, I got under it while someone was turning the wheel was not not able to notice any play in the steering linkage at all, only in the box, I tried to tighten down the allen bolt, but did not make a big difference.

Any advise would be helpful, I normally do most of the work on my own vehicles, but have never owned a MB before (just bought it last weekend)and my only other experience with diesels is our Dodge 3500 Cummins.

Thanks

Reply With Quote
  #2  
Old 03-16-2005, 06:21 PM
sixto's Avatar
smoke gets in your eyes
 
Join Date: Jun 2000
Location: Eastern TN
Posts: 20,841
The steering box play adjuster spins clockwise to increase play and counterclockwise to reduce play. If you did not know this, you may have made things worse with your adjustment. I think you're looking for no more than an inch of play at the circumference of the steering wheel. If you go too thin on the play, you'll eat up the innards of the box in no time. It's normal to have more play when the wheels aren't pointed dead ahead.

Check also that the bolts holding the steergin box to the frame are properly tightened. This gets into a sticky area because MB uses encapsulated bolts (bolts with baked on Loktite) that should not be reused.

Sixto
95 S420
87 300SDL
Reply With Quote
  #3  
Old 03-16-2005, 06:29 PM
Registered User
 
Join Date: Jul 2003
Location: Ocean Isle Beach, NC
Posts: 2,512
The steering box ought to be the last thing you adjust to take out slack. Usually something in the front end suspension is the casue. My 240D, owned since new, has never had the box adjusted.

Len
'83 240D 343,000 miles
Reply With Quote
  #4  
Old 03-16-2005, 06:35 PM
schwarzwagen's Avatar
Registered User
 
Join Date: Nov 2003
Location: Nashville, TN
Posts: 300
Quote:
Originally Posted by sokoloff
The steering box ought to be the last thing you adjust to take out slack. Usually something in the front end suspension is the casue. My 240D, owned since new, has never had the box adjusted.

Len
'83 240D 343,000 miles
really, i have replaced my box once and all susp. components all around the same time. i notice a great difference with the new box v. the old one.
__________________
Jonathan
1998 S600
2001 E430
1994 E320
1991 560SEL
1994 Turbo R
Reply With Quote
  #5  
Old 03-16-2005, 08:58 PM
Registered User
 
Join Date: Mar 2005
Posts: 25
Thanks for the info, I have not gotten a hold a manual yet, so I appreciate letting me know that their adjustment screw is counterclockwise, All of the vehicles I have adjusted have been the opposite. Is there an indicator to know when you have hit the limit of the adjustment.

Everything else seems tight to me, yet there is a little bit of a warble at interstate speeds, I am going to have alignment checked, as gearbox slop should not stop an alignment from being done. Also tires have been balanced and are newer.

It is difficult when I first purchase a used car, trying to figure out where someone else left off in maintenance and learning the difference between quirks and something being wrong.

So far I love the car and the ingenius engineering that no one else could touch in the mid 80's and today.

Thanks again.
Reply With Quote
  #6  
Old 03-16-2005, 09:37 PM
sixto's Avatar
smoke gets in your eyes
 
Join Date: Jun 2000
Location: Eastern TN
Posts: 20,841
Another MB trick is that when you have an alignment done, don't let them hook the steering wheel to the brake pedal. There's a cap somewhere on the steering box. Remove the cap and fit an appropriate size rod (screwdriver should do) into the hole and engage the slot in the steering shaft. That is the proper straight ahead setting. If the steering wheel is off, reset the steering wheel. Chances are you'll be forever correcting your alignment if you force an alignment without keying off the center position of the steering box.

Basic advice on this is let an MB dealership do the alignment or take it to someone who knows about locking the steering box. "Huh?" is your cue to go somewhere else.

Sixto
95 S420
87 300SDL
Reply With Quote
  #7  
Old 03-17-2005, 10:19 PM
Registered User
 
Join Date: Mar 2005
Posts: 25
Thanks again for the advise, I backed the adjustment bolt on the gear box all the way out and it is about perfect. Then I had it aligned and it runs straight down the road smoothly. Although as an FYI, I talked to the dealer and they stated that in 85 the 300 series did not need to be locked from the gear box, also I was unable to find any type of cap on the gear box, anyway thanks again for the info.

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
126 frozen steering lock/tumbler removal (fairly easy, but long) jbaj007 Tech Help 4 09-21-2019 03:19 PM
'86 300E - Need Quick Help with Steering Gearbox Problem Phalcon51 Tech Help 11 11-27-2004 05:36 PM
Steering Coupler / Gearbox Replacement... schouboy Tech Help 1 08-03-2004 05:47 AM
Is it hard to retrofit a sportline steering gearbox to a regular 300e? 6cndmbz Mercedes-Benz Performance Paddock 0 01-08-2004 11:13 PM
steering offset geometry bobbyv Mercedes-Benz Wheels & Tires 0 08-19-1999 09:20 PM



All times are GMT -4. The time now is 06:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page