|
|
|
#1
|
|||
|
|||
95C220 Hazard Light Switch
Does the wood counsel need to be removed first. (If so, any tips.)
If not, does the hazard switch just pull out? Thanks for any help. |
#2
|
|||
|
|||
wood console needs to be removed, bizarrely enough the hazard switch come off with the wood console.
tips, do you know how to remove the radio? because that needs to come out, then you will see the four screws that get removed and then you can snap out the wood console. When I do this I have already pulled out the center console, ash-tray, and cubby hole. so if you attempt this without removing those items be careful I didn't forget to mention a step. To keep from scratching the wood, I use painters tape, and apply the tape along all edges of plastic dash and wood that could be effected, I also lay towels over console wood trim. The screwdrivers I use are stubby - short handled to prevent slippage. In reasembly it is important to put everything back together with the right tighness and layout so you don't get annoying vibrations. Take notice of the screw tighness when you UN-TIGHTEN them, so when you put it back together it is kosher. |
#3
|
|||
|
|||
Thanks - it was easy.
Got the radio keys and was able to replace switch in half hr. Thanks again.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SRS light - seat belt switch | joselu43 | Tech Help | 1 | 02-07-2004 04:05 PM |
1986 420SEL Hazard light switch | rkphoto | Tech Help | 5 | 01-06-2004 02:04 PM |
Stupid question, what's the double click on the light switch? | spinedoc | Mercedes-Benz SL Discussion Forum | 5 | 03-27-2003 07:44 PM |
Light Switch Question | hippie_elmo | Vintage Mercedes Forum | 4 | 11-20-2001 10:59 AM |
81 300SD light switch | SYDDONNA | Tech Help | 2 | 05-20-1999 01:24 AM |