|
|
|
#1
|
|||
|
|||
560 sel ride height
I just replaced my accumulators on my 87 560. The tell tale sea foam came out of the old cells so I know they were gone. After successfully putting the new ones on and topping up the fluid with MB approved, the ride got a little softer but the back end is still sagging very low. I actually took the ajustable rod out of the height controller and manually moved the bar as high as it would go and as low as it would go. All I got out of this was about a 1 inch rise in the hight of the car. The pump is working fine as I can open the bleeder and fresh fluid is bled out.
If anyone out there can guide me in the right direction it would be greatly appreciated. If it is the level controller, what will one of them run me and are they easy to install? Thanks Jamie. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
SDL ride height | Brian Carlton | Diesel Discussion | 29 | 10-15-2004 11:01 PM |
1983 300SD or 1987 560 SEL | BenzFreak | Diesel Discussion | 2 | 05-19-2003 01:05 AM |
1983 300SD or 1987 560 SEL | BenzFreak | Mercedes-Benz Wheels & Tires | 0 | 05-18-2003 09:07 PM |
400E Ride Height | timreid | Tech Help | 0 | 05-12-2003 02:42 PM |
What is the FACTORY procedure for setting ride height with Self-Leveling | fhmajid | Mercedes-Benz Performance Paddock | 6 | 10-28-2002 07:51 AM |