PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   2001 C320 Sway Bar Bushings Part # (http://www.peachparts.com/shopforum/tech-help/121891-2001-c320-sway-bar-bushings-part.html)

Evan 04-27-2005 10:02 AM

2001 C320 Sway Bar Bushings Part #
 
Hi, I am looking for the part numbers on my front and rear sway bar bushings on my 2001 C320. It is a non-sport model. So it just has the regular suspension. I noticed they are looking stretched around the edges and some clunking going on when turning and the car is moving.

mpolli 04-27-2005 01:27 PM

I would just call Phil and then you can order them at the same time.

Mike

Evan 04-27-2005 03:41 PM

Who is Phil, and how do I call him?

carson356 04-27-2005 05:09 PM

part number
 
evan, look at the attached picture and let me know if it shows your part

Evan 04-27-2005 05:25 PM

Yes #20 In The Picture

DR.DIESEL 04-27-2005 05:44 PM

Just so you know, those sway bar end links have been the biggest source of
clunking in the front ends of w203 cars. All the parts in that picture were updated by MB in 2003.
DTB
Date: July 29, 2003
Order No.: P-B-32.20/17a
Supersedes: P-B-32.20/17 dated July 24, 2003
Group: 32
Revision:
SUBJECT:
VIN No. updated for Exxxxxx
Model 203.040/061/064/065/081/084/261/264/281/284/740/747/764
Up to VIN A452736, F356257 and E014641
Knocking or Rumbling Noise From the Front Axle Area on Rough Roads
If you receive customer reports in the above model vehicles of a knocking or rumbling noise from the front
axle area when driving on rough roads, check the ball joints for the front torsion bar links for excessive
wear. The excessive wear can be caused by moisture entering through the sealing bellows. In this case,
there will be noticeable play in the ball joint. To resolve, install new torsion bar links. As of October 2002
production.
Repair procedure, refer to WIS document no. AR32.20-P-0300P.
Parts Information
Qty. Part Name Part Number

2 Torsion bar link rod 203 320 28 89**

Other possible cause -

DTB Date: April 7, 2004 Order No.: P-B-33.10/11 Supersedes: Group: 33
SUBJECT: Model 203.040/061/064/065/261/264/740/764
Rumbling Noises While Driving Over Bumps or On Bad Roads
If you receive customer reports in the above model vehicles of rumbling noises while driving over bumps or on bad roads, please refer to the below possible causes / remedies. Experience has shown that knocking or thumping noises from the front axle has nothing to do with the lower cross strut or the suspension strut.
Cause 1: The rubber mount on the torque strut is cracked and losing fluid. Affected vehicles are up to VIN A436252 and F339810.
Remedy: Replace the rubber bushing only. Refer to WIS document AF33.15-P-1120BG.
Cause 2: The drop links of the torsion bar may have too much play due to corrosion. Affected vehicles are up to VIN A449884 and F352398
Remedy: Replace the torsion bar drop links. Refer to WIS Document AF32.20-P-1105AG.
Cause 3: The rubber mount of the torsion bar has too much play and is worn out. Affected vehicles are up to VIN A407163 and F311913
Remedy: Replace the rubber mount of the torsion bar. Refer to WIS Document AF32.20-P-1001AG.
Cause 4: Excessive play in the torque strut joint, which may cause knocking noises. Affected vehicles are up to VIN A098943 and F070099
Remedy: Inspect the torque strut joint by raising the vehicle on a chassis lift so that the wheels are not under tension. Manually move the torque strut in a vertical direction up and down in the vicinity of the ball joint while looking for play. If play is present, replace the torque strut. Refer to WIS Document AR33.15-P-0160P.
Cause 5: The distance between the rebound stop and the rubber mount for the shock absorber strut is too small. Affected vehicles are up to VIN A072536 and F049970.
Remedy: Check the clearance between the rebound stop and rubber mount on the shock absorber strut. The clearance must be between 1-2 mm. If there is not enough clearance, replace the rebound stop. Refer to WIS Document BA32.25-P-1006-01B.

Parts Information Qty. As Required Rebound Stop A203 323 02 32 ** As Required Torque Strut left A203 330 01 11 ** As Required Torque Strut right A203 330 02 11 **

Hope this helps.
Dr.D

carson356 04-27-2005 07:35 PM

bushings
 
Quote:

Originally Posted by Evan
Yes #20 In The Picture

there are some variables, i will need your vin to get you the proper number

mpolli 04-27-2005 10:00 PM

Quote:

Originally Posted by Evan
Who is Phil, and how do I call him?

Phil, of Fastlane, the people who run this site. Just click on Fastlane or Buy Parts.

Mike

Johnhef 04-27-2005 10:11 PM

The standard "noisy front suspension" package for 203's usually includes both sway links and bushings, now they're starting to give out the bushing caps as well. I'm not sure of the reason yet. To me they look like the old ones but they do have a different part number on them.


All times are GMT -4. The time now is 12:50 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website