500sl Trunk Opening Problem
 

Howdy!
We have done a complete repaint and seals for the trunk lid of a 500SL.
We cannot get the trunk lid to open.

Any clues?

Thank you very much,

JONESTSJ

Not a fun Problem!
 

Did you mess with the locking mechanism any? If you just replaced the seals then you would not have created a problem, but if any of the trim or locking mechanisms were removed and not installed properly the bar that connects the button (between the tag and the tailight) could have come disconnected from the lock, or the vacuum line that unlocks it could have come disconnected. You can remove the license plate light cover and assembley on the passenger side and reach the bar, pull it towards the fender, or push, I can't remember, either way it should open the trunk and allow you to remove the trim inside to fix your problem with either an inoperative lock or dislocated push bar. Good luck!
Brian

oh, that only works on the 129 chassis, I am sure if it is a 500SL that is what you are talking about.