|
|
|
#1
|
|||
|
|||
500sl Trunk Opening Problem
Howdy!
We have done a complete repaint and seals for the trunk lid of a 500SL. We cannot get the trunk lid to open. Any clues? Thank you very much, JONESTSJ |
#2
|
|||
|
|||
Not a fun Problem!
Did you mess with the locking mechanism any? If you just replaced the seals then you would not have created a problem, but if any of the trim or locking mechanisms were removed and not installed properly the bar that connects the button (between the tag and the tailight) could have come disconnected from the lock, or the vacuum line that unlocks it could have come disconnected. You can remove the license plate light cover and assembley on the passenger side and reach the bar, pull it towards the fender, or push, I can't remember, either way it should open the trunk and allow you to remove the trim inside to fix your problem with either an inoperative lock or dislocated push bar. Good luck!
Brian
__________________
Brian W. Heitman www.MBCA.org/northtexas Join MBCA!!! |
#3
|
|||
|
|||
oh, that only works on the 129 chassis, I am sure if it is a 500SL that is what you are talking about.
__________________
Brian W. Heitman www.MBCA.org/northtexas Join MBCA!!! |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
450 SL Trunk Problem | tomward | Mercedes-Benz SL Discussion Forum | 1 | 01-05-2005 12:14 PM |
Trunk lock problem | kotarbi | Diesel Discussion | 11 | 12-03-2004 03:13 PM |
90 500SL Need help with hardtop install problem | warren128 | Mercedes-Benz SL Discussion Forum | 2 | 06-20-2004 10:23 PM |
S500 ( W140 chasis ) trunk opening Gremlins | Jere | Tech Help | 22 | 02-05-2002 12:24 PM |
1992 500SL Start Problem | J L Roe | Tech Help | 2 | 03-13-1999 03:01 AM |