|
|
|
#16
|
|||
|
|||
Can you get to it with a socket? If you have to you can use an extension on it.
__________________
“Fundamentally, sustainable development is a notion of discipline. It means humanity must ensure that meeting present needs does not compromise the ability of future generations to meet their needs.”--- Gro Harlem Brundtland 1989 300se 250,000 1983 BMW 528e 100,000 1999 Olds Alero 80,000 These pretzels are making me thirsty. |
#17
|
|||
|
|||
Thanks for the great response to my hex bolt removal question, I was able to use the Crafstman Bolt Out impact type that has a center 3/8" drive set up instead of a wrench, it was the difference due to clearance limit.
Great suggestion. Now that the camshaft is out I need to keep the valves up against the head in order to keep them from falling once I try to remove the keeper from the top side witout removing the head, I have a spring compressor. How much air pressure do I need to inject into the cylinder and does it have to be constant or can I pressure it up with a electric bicycle tire compressor and leave it hooked up at about 95 psi. I could purchase a small air compressor if needed fom sears or so. Need your pro advise.
__________________
Thanks, Juan |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
94 E320 Water Pump replace method | 320wheels | Tech Help | 11 | 07-01-2013 02:35 AM |
Motor & Transmission mounts | Tim the Taxman | Diesel Discussion | 11 | 04-13-2004 08:32 AM |
Console removal & service, 74 SL | WCF | Mercedes-Benz SL Discussion Forum | 1 | 03-21-2004 07:43 AM |
Half Shaft Replacement Tips and other advice needed! | Morphous | Diesel Discussion | 2 | 02-20-2003 04:46 PM |
M116 removal from 82 380SL | rstarkie | Tech Help | 3 | 11-14-2002 07:03 AM |