|
|
|
#1
|
|||
|
|||
Whats the book labour for a radiator installation on a 300E?
as title says.
__________________
87' 300E champagne - Euro headlights and corners, 8-hole rims, 140,000miles/220,00km. |
#2
|
|||
|
|||
actually, does anyone have a diagram showing how to remove the radiator from the mb cd manuals.
thanks
__________________
87' 300E champagne - Euro headlights and corners, 8-hole rims, 140,000miles/220,00km. |
#3
|
||||
|
||||
There is a DIY write up at the top of this site. Its an easy DIY job, just a little messy.
Flush your coolant if its time, at the same time.
__________________
'90 300SE 298k -300K and it gets put into retirement. '80 300D 255k Purchased new by family in 1980. Had a: 1973 220 (gas) 1980 300SD 1992 400E |
#4
|
||||
|
||||
Quote:
And if you have catch basins to hold the fluid that will pour out of the bottom connections, it's not that messy either...
__________________
2009 ML350 (106K) - Family vehicle 2001 CLK430 Cabriolet (80K) - Wife's car 2005 BMW 645CI (138K) - My daily driver 2016 Mustang (32K) - Daughter's car |
#5
|
|||
|
|||
ok thanks,
but i just want a diagram from the cd manual also.. although that DIY posted by that guy looks very helpful.
__________________
87' 300E champagne - Euro headlights and corners, 8-hole rims, 140,000miles/220,00km. |
#6
|
|||
|
|||
I would be surprised if the book gives more than .5 hours for radiator R&R.
Good luck, |
#7
|
||||
|
||||
Yea radiator replacement is a good and easy DIY job. I didnt have the reference to the posting when I changed the radiator on the 260E. Quite straightforward and the sticky on this website would def. come in handy.
good luck.
__________________
Whether you think you can or cannot, Either way you're right!. by Henry Ford. |
#9
|
|||
|
|||
sorry to say if u need directions on removing a radiator,wich has 4 clips 2 hose clamps,and 2 tranny lines.Than you should not atempt to do it....And if u do then there is another little hint when pouring in the coolant.Make sure the ignition is on and you have the heater set to defrost.now pour in the collant slowly switching with water every 2 liters.till it is full.than run car with rad cat off so sistem can bleed /.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebadging '87 300e | emr0591 | Detailing and Interior | 6 | 09-04-2007 09:12 AM |
'86 300E vs '91 300E... Any opinions out there??? | pjtib | Tech Help | 23 | 05-04-2005 09:26 PM |
300E FIRST-gear start | brewtoo | Tech Help | 16 | 03-11-2005 05:27 PM |
92/93 300E or 94/95 E320 | argyleco | Featured Cars | 8 | 03-14-2004 12:59 AM |
*CLEAN* W124 Gray MB-Tex Front Seats / 300E 260D 300D (300E 2.8) and (W124 Wagons) | FA22 | Mercedes-Benz Used Parts For Sale & Wanted | 5 | 03-01-2004 08:40 PM |