|
|
|
#1
|
|||
|
|||
HELP!!!!HELP!!!! FAN PULLEY M103 Engine
I can not for the life of me get the allen key on the fan pulley loose. I need help with ideas??? I need to get to the last bolt that holds the belt tensioner bracket on. So let me calm down. I am trying to remove the fan pulley and as mentioned it is tough. I must be doing something wrong. Thank you for listening. George
|
#2
|
||||
|
||||
if you're trying to do what I think you're trying to do, you need a special tool to hold the fan in place while you undo the nut. its a rod with a 90 deg bend on the last half inch. do a search on viscous fan clutch and you should find out more
__________________
1987 300e manual 250,000 km (sold) |
#3
|
|||
|
|||
that is right george it is a long round handel that is bend at the end ,and it is placedon the oposite side of the the fan clutch.that hub where the fan cluch is bolted to has 4 holes where ith pulley for the cerpintine belt is bolted to.those u can not use.but then there are 2 empty holes where that rod fits in(the 90degee bend) and than u just unscrew the 8 mm allen..just make sure that allen in All the way,cause if u stip that bolt you are in big dudu
|
#4
|
|||
|
|||
Quote:
If you'd like to see the tool that I think you'd need do the following steps: go to www. startekinfo.com. Then click: 1.MB special tools 2.E-special tools 3.Service group order 4.#20 engine cooling system 5. 103.589.40.00 - bracing tool Good luck. |
#5
|
|||
|
|||
Thanks everyone I did see the hole on the back of the fan pulley. I decided to utilize a strap wrench and it worked like a champ. One tough allen to remove and there was no locktite on it thank god. THank you for all of your help.
George |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
M103 engine doesn't start | ThomH | Tech Help | 8 | 08-26-2004 02:58 AM |
Rust Free 82 300SD in Dallas TX needs new home!!! | bodyart27 | Diesel Discussion | 47 | 08-07-2004 08:54 AM |
2000 ML320 engine idler pulley | BenzBob | ML, GL, G-Wagen, R-Class, Unimog, Sprinter | 2 | 12-15-2003 10:36 AM |
Check Engine Light M103 | d2bernhard | Tech Help | 2 | 01-15-2003 02:37 PM |
M103 Engine Torque Specifications | Maddog | Tech Help | 0 | 01-02-2003 12:53 PM |