PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   1995 E300D Glow Plugs Problem (http://www.peachparts.com/shopforum/tech-help/131705-1995-e300d-glow-plugs-problem.html)

JRobock 08-18-2005 01:29 PM

1995 E300D Glow Plugs Problem
 
I recently had the situation where the glow plug light would not come on with the ignitition key but the car started, although roughly. I had all of the glow plugs changed. I bought the car with 97,000 miles and had 106,000 at the time.

I added a wiring harness in my trunk for a trailer and left the ignition in the on position without starting the car while connecting this wiring. Now, the dash light does not come on and I can start the car (roughly). The light comes on after a minute and then goes out after another minute or so.

Did I cause the glow plugs to fail by leaving the ignition on without the car running or is this unrelated? Or, could the wiring to the back tail light harnesses for my trailer connection have caused this? I didn't remove the harness to test this notion. Any suggestions or help would be appreciated as it cost me $450 to have the glow plugs changed a few months ago.

Jim H 08-18-2005 04:16 PM

Quote:

Originally Posted by JRobock
...Now, the dash light does not come on and I can start the car (roughly). The light comes on after a minute and then goes out after another minute or so...

This sounds like a few GPs are not being powered. They may be burned out, or wires may have come loose.
Quote:

...Did I cause the glow plugs to fail by leaving the ignition on without the car running...
No, the relay will apply power for a limited time, 30-45 seconds or until you start the engine. It will then switch off and stay off, no matter how long you leave the key on.
Quote:

...could the wiring to the back tail light harnesses for my trailer connection have caused this? I didn't remove the harness to test this notion. ...
Not likely, the GP harness is contained in the engine compartment, while I assume the trailer connections were made at the rear.
Quote:

... Any suggestions or help would be appreciated as it cost me $450 to have the glow plugs changed a few months ago.
Well, you can test the plugs yourself if you are familiar with a multimeter, just disconnect the connector at the relay and measure resistance of each plug, connecting the meter from each socket in the connector to chassis ground. 0.8 ohms or so is 'good' while 'infinite' ohms is burned out, or a bad wire. Connecting from the socket to the plug terminal will measure resistance of the wire, which will probably 0.0 ohms if it is good, and 'infinite' if it is broken or bad.

Your tech can check them for you, too. If he does, and some are burned out, ask if there is any warranty, since they should last more than a few months.

Best Regards,
Jim


All times are GMT -4. The time now is 01:58 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website