Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 10-24-2005, 10:33 PM
Registered User
 
Join Date: Jan 2004
Location: Titusville, FL
Posts: 241
W124 Dash Removal

I have searched the archeives and not found an answer. I am removing the dash and think I have done everything the shop manual said to do (as I understand it). Both ends seem loose but the center seems quite tight and not moving. Have I missed something in the center or does it take some gentle persuasion?
Thanks,
Lee

Reply With Quote
  #2  
Old 10-25-2005, 01:18 PM
froghunter
Guest
 
Posts: n/a
The defrost ductwork is attached to the underside of the dash and is a friction fit with the top of the airbox. It may need persuasion upward. Assuming you removed all fasteners.
Reply With Quote
  #3  
Old 10-28-2005, 12:12 AM
Registered User
 
Join Date: Jan 2004
Location: Titusville, FL
Posts: 241
Thanks,
I rechecked all the instructions to confirm that I got them all and then used a lot (in my mind) of force/wiggling to get it loose.
Lee
Reply With Quote
  #4  
Old 10-28-2005, 12:33 AM
Registered User
 
Join Date: Jul 2001
Location: Mexico
Posts: 550
You need to pull a little hard when you have it loose, it's almost like air locked or something. Also, is the cable behind the brake pedel unhooked to give it some slack.
__________________
87' 300E champagne - Euro headlights and corners, 8-hole rims, 140,000miles/220,00km.
Reply With Quote
  #5  
Old 10-28-2005, 03:10 AM
Registered User
 
Join Date: May 1999
Location: Sacramento, CA
Posts: 1,478
On my '87, the center of the dash sat on two posts sticking up from the center console. Short of removing the entire center console (which I did not want to do), it required a lot of effort to squeeze the dashboard over the posts. And then again getting it back over them, and back fitting properly again.

I'm not sure if anyone else has run into this problem, but I did at least.

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 07:09 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page