Finally pulled the interior door panel today (I got the guts to pull an engine but messing with mercedes trim is terrifying!!!) I found why the fuse was blowing right away. All the bolts holding the power regulator assembly were completely loose, the whole thing was flopping around. I tightened everything up, put in lock washers.
Now I notice however that the power regulator assembly at the end of its travel cycle (window down) still flexes a little as if something isnt quite aligned. I adjusted the down window stop as best I could, but the thing still quivers a little.\ (1) Are there any adjstment procedures? (2) What should I use for lube--right now I put Vaseline over evreything.. (3) Should itflex slightly? |
All times are GMT -4. The time now is 02:40 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website