NO MOVEMENT IN AUTO TRANSMISSION

I HAVE POSTED THIS BEFORE BUT I WANTED TO TRY AGAIN, THE TRANSMISSION IN MY 82 300D WILL NOT GO INTO ANY GEAR, I HAVE CHANGED FILTERS, FLUID, INSTALLED NEW BUSHINGS ON SHIFT ROD AND MADE SURE THAT EXTERNAL LINKAGE WAS OK, ANY SUGGESTIONS OF SOMETHING ELSE I MIGHT TRY TO CURE THIS PROBLEM

[300EVIL]

did this problem happen suddenly ( over night) or was it gradual? (vibrations, not working in just a few gears?)
good luck!
Adam

THIS HAPPENED SUDDEN, I HAD NOT EXPERIENCED ANY PROBLEMS AND I BACKED OUT OF MY GARAGE AND WHEN I PUT IT IN DRIVE IT WOULD NOT MOVE EITHER FORWARD OR REVERSE

[cth350]

Isn't that the classic symptom of the B2 failure?
Which would mean it can be fixed "easily".

-CTH

my feelings also, thats the reason i posted it because usually when something like this happens suddenly it is something simple

[stevebfl]

Being at home I can't verify power flow but the B2 problem only affects going forward if I recall. I think reverse is just the forward brake discs (clutches that anchor to the case) and the one way clutch. Could be wrong though.

I would check your system pressure. I have seen a number of front pump problems cause a no-go situation.

Do you get a speedo reading when you rev the motor in drive??

no , i don,t get a speedo reading

let me also say that it is not pumping fluid