PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   Wrong time of year, but simple AC question (http://www.peachparts.com/shopforum/tech-help/143959-wrong-time-year-but-simple-ac-question.html)

pberku 01-29-2006 10:00 AM

Wrong time of year, but simple AC question
 
Here is a simple question, with hopefully a very simple answer re an AC system:

Is the Pressure in the evaporator, higher with the compressor ON, or with the compressor OFF?

The reason I am asking is that I have a leaking compressor, and possibly a leaking evaporator as well, and I am trying to determine which of the two components has a larger leak. I noticed that if the compressor is ON, I loose the refrigerant within 5-6 days. With the compressor, off the refrigerant lasts at least 3-4 Months, So I am trying to determine if I can get away by just replacing the compressor, without replacing the evaporator as well. At least for now

I am thinking that if the pressure in the evaporator is LOWER with the compressor ON, it will then leak even Less, so I maybe able to get away without replacing it, at least for awhile.

Thanks

stevebfl 01-29-2006 10:10 AM

The pressure in the evaporator is lower when operating. Usually about 100psi when off and around 30-40 when running.

pberku 01-29-2006 10:21 AM

Thats what I was hoping to hear. So based on that it means that the evaporator will leak even less when the compressor is ON. So I can safely assume that if I only replace the compressor for now, and leave the evaporator be, than I should be OK with the evaporator for awhile.

Matt L 01-29-2006 10:22 AM

You lose refridgerant so fast with the compressor running that you'll probably go more than 4 months after changing just that. As hard as the evaporator is to get to, compared to the compressor, I'd do just the compressor first. An extra fill is nothing compared to an evaporator R&R.

Diesel Giant 01-29-2006 10:27 AM

The evaporator is supposed to be at around 40 degrees temp at design conditions. That is 37 psi in the evap and 157 psi in the condensor or high side R-12 at design conditions of 95 degree ambient. You car uses an expansion device instead of a fixed metering device. When the car is off the pressure in the evap will rise slightly closing the expansion valve and sealing the evaporator to a degree. That is why you loose less refrigerant when the car is off.

Here is some A/C help for your car.

http://dieselgiant.com/repairyourac.htm

Arthur Dalton 01-29-2006 10:50 AM

... just some added refrigeration info..
There are two sides to a refrig loop.. low side/high side...
When compressor is running , the seperation points of the two sides are at the compressor [ internally , between suction/pressure ] and whatever type metering device is used [ Expansion valve, cap tube. POA valve, etc]
Anything from the compressor pressure to the metering valve is referred to as the high side and anything between the metering component and suction port back at compressor is the low side.
All pressure are equalized when the unit is not being used , but when the compressor is on, the high side will be more pressure than a dormant unit and the low side will be less.
Many hard to find high side leaks can only be found when the high side is pressurized b/c the are more likely to leak at the higher pressures of a running unit, whereas an evap leak is more likely to leak sitting dormant as the equalized pressure of a charged unit is higher in the evap [ low side] than when unit is running.
When looking for an evap leak, some techs will roll up the windows , close the doors and let the car sit overnight [ charged w/refrigerant]. The next morning they will stick a sniffer up into the evap drain holes .. the refrig. is heavier than air , so it tends to settle at the lowest point and can be detected.
Same technique is used by commercial refrig techs....they always snif the floor of a unit that is suspect of evap leaks.

pberku 01-29-2006 12:18 PM

Hi Arthur, and Diesel Giant

Thanks for both of your explanations. Your responses also confirm that my evaporator leak is not nearly as bad as my compressor leak. Also based on Arthur's explanation, and assuming that I do change only the compressor, than the longer that the compressor is on, the less refrigerant I should expect to loose through the evaporator. Under the circumstances I guess that this is a good thing.


Thanks

ILUVMILS 01-29-2006 01:28 PM

Hi pberku, another thing to consider is the climate at your location. During the winter, while your car isn't being used, the pressure in the evaporator is much lower than it is during the warmer months. Install a gauge on the low side and see what it says after the car has been sitting overnight in -5C weather.

pberku 01-29-2006 05:30 PM

Quote:

Originally Posted by ILUVMILS
Hi pberku, another thing to consider is the climate at your location. During the winter, while your car isn't being used, the pressure in the evaporator is much lower than it is during the warmer months. Install a gauge on the low side and see what it says after the car has been sitting overnight in -5C weather.

I was thinking about what you said, but than realized that in the winter the evaporator would actually be in higher ambient temperature not lower.

The reason I am saying this is that the evaporator is within the car's cabin, so in the winter, when the heater is on, the temperature of the cabin is usually higher than it is in the summer, when hopefully, with the AC running it is lower. Additionally, the evaporator is mounted right behind the hot heater. core. This further increases its temperature in the winter.

ILUVMILS 01-29-2006 09:16 PM

While the evaporator and heater core are next to each other physically, they are separated by the blend-air flap(s). The point I was trying to make was that the pressure of the A/C system, when not in use, varies with ambient temperature. The lower the temperature, the lower the pressure. Sorry for the mis-understanding.:o


All times are GMT -4. The time now is 08:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website