|
|
|
|
|
#1
02-01-2006, 06:23 PM
|
||||
|
||||
|
too much heat
I took the dash apart to replce bad actuators for the heater system
Got all them working , but noticed after all together that the heater control was blowing hot air on every position but extreme cold position Noticed that the monovalve had a broken spring washer Rebuilt unit No water sneaking by monovalve , also checked to voltage and no voltage at plunger Do I need voltage to keep it closed? I assume it does??? What makes it close The control unit??? Is there an air flap that has to open to send colder air in to unit??? The ousde air flaps are open Any help would be appreciated before I go nuts Bad enough ripping dash apart to repair air diaphrams but now more headaches Thanks
__________________
[B]Mike Y. 00 sl500 sport 88 560 sl (sold) Last edited by myanoch; 02-01-2006 at 07:13 PM. 
|
|
#2
02-01-2006, 08:51 PM
|
||||
|
||||
|
found problem to be inside temp sensor
Can't seem to find one Non listing on fast lane Is this a dealer item only
__________________
[B]Mike Y. 00 sl500 sport 88 560 sl (sold)
|
|
#3
02-01-2006, 09:30 PM
|
||||
|
||||
|
You can try calling Phil at fastlane. He may be able to get the part even though it is not directly listed on fastlane.
__________________
Ali Al-Chalabi 2001 CLK55 1999 Dodge Ram 2500 Cummins Diesel 2002 Harley-Davidson Fatboy Merlin Extralight w/ Campy Record
|
|
#4
02-01-2006, 09:46 PM
|
||||
|
||||
|
I will call him in the morning Thanks
__________________
[B]Mike Y. 00 sl500 sport 88 560 sl (sold)
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
