|
|
|
#1
|
|||
|
|||
got the car back from the shop...mech there said they were full and couldnt acomodate the car till next week but ask him to give it a look over.
he said that the electrical wiring was in shambles and some of the connectors are lose. an hour later and $10 of clips and stuff and the cars idle problem is gone. in traffic it no longer stumbles of idle and even after giving it a go for some time and stopping on a dime the idle remains rock solid!! what did he do, he wont tell me cus' its his secret?! any ideas? now there seems to be a new bug, actually an old bug that made itself more evident as a completely different problem. when i rev my car in 1st it blitz past the redline and even the shift line...good fro about 7000+ rpm, 2nd gear comes and it wont rev past 6000, 3rd 5000 and so on? huh? i am confused...with the shop fully booked for sometime i cant stop racking my head for a probable answer and cant get any peace. i gave the engine a compression test and leak down test an it passed w/ flying colors. havent been able to check valve timing and ignition advance,yet. gave it the old racer test (put your face to the exhaust and if its hot and stings the eye...) crude but gives a good idea...its hot and hurt my eye, for good measure I changed the oil,fuel and air filter along woth new oil and spark plugs...all due for change anyway. Once again im at a loss, any assistance is very much welcomed. thanks in advance |
#2
|
|||
|
|||
Running out of revs is due to "lack-of" getting in or out. Getting the exhaust out of the exhaust system TOO SLOW will cause the engine to run-out quicker in each gear. Also getting enough air & OR fuel into the engine can cause the same thing.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
#3
|
|||
|
|||
Rob
The mechanic won't tell you his secret because if it was like my 16V ... I unplugged all the connectors, cleaned them, plugged them back in and my idle/stalling problem was fixed. I have no idea which connector was giving me the trouble. Re the 7/6/5000 rpm I agree with the previous post. If the exhaust is okay, drive it without the air filter, and check the fuel filter. Robby |
#4
|
|||
|
|||
problem 190
i got some down time this weekend and im going to give the fuel pump and fuel damper a check.
exhaust is ok and just put in a new filter. i got a feeling the problem is in the fuel delivery...not enough pressure to pump in the gas. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Return of idle problems - '91 190E 2.3 | sbourg | Tech Help | 11 | 05-19-2003 10:25 AM |
95s 320 problems are they common?AC/LOCKING system/head gasket leaks | joe cantalino | Tech Help | 0 | 05-14-2003 10:00 PM |
Finally my 16V is under BOOOST!!! | Clinton | Mercedes-Benz Performance Paddock | 8 | 12-06-2000 03:32 PM |
16v clutch/ transmisson problems? | mauro | Tech Help | 3 | 07-17-2000 02:37 PM |
'85 16V engine problems | cresko | Tech Help | 5 | 02-16-2000 11:20 AM |