Hi all,Im very exited! This morning,I had a set of H&R spring installed in my car.I chose #2 pads in the front and #3 in the back.The look?, so sweet (at least to me.My firstM.B.).To my surprise,the ride is better than stock.I use Bilstien comfort shocks.Stirring is a lot lighter too.The car rides on 16 inch rim with 215-50.The set up,lowered the front 1.5 inches and 1.25 in the back.The back is about half inch higher just as I wanted to.Theres no rubbing at all.My question is,do I have to put a thicker sway bar and strut bar? Need suggestions from all Benz lover. Regards,Clauser.
|
Clauser:
That's sounds great! I've got a set of Bilsteins and H&Rs ready to go, but have been pondering which pads to use (I purchased an assortment). Do you recall what the stock pads were? Thanks! Brian |
Spring pads
Brian,
My stock pads where #3 in the front and #3 in the back. Remember,I used comfort shocks and I have a steel encapsulation pan. |
All times are GMT -4. The time now is 10:09 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website