|
|
|
|
|
#1
03-13-2001, 07:34 PM
|
|||
|
|||
|
Regarding a '79 300SD W116, with a fairly new climate control servo, and a newly working aux. water pump. My heat is amazing, well at first, then I start to sweat. My dial does not change the temp in the car. What part should I look at to resolve this? Any suggestions for repair would be appreciated.
|
|
#2
03-13-2001, 08:06 PM
|
||||
|
||||
|
I had the same problem with my '85 and the whole mono valve had to be replaced, not just the "insert". I'm not sure if you have this control valve, but I tried a new controller first also.
__________________
When I close my eyes, and inhale, I can smell No. 2. 
|
|
#3
03-13-2001, 09:52 PM
|
|||
|
|||
|
Thanks dan for the reply. My car has a climate control servo rather than a monovalve and it is new so I don't think it is that. I appreciate the input.
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My kids are freezing!! no rear heat | Rondi Rowan | Tech Help | 6 | 01-17-2005 02:49 PM |
| Question- electrical troubleshooting- oscillation temp gauge+ fuel gauge with turn | ericgr | Mercedes-Benz SL Discussion Forum | 5 | 09-30-2004 03:36 PM |
| E320 95 turn signal does not work | duc4208 | Tech Help | 4 | 09-05-2004 01:36 PM |
| Another 140 with no heat | rrobben | Tech Help | 12 | 08-21-2003 10:34 PM |
| Heat and No-Starts: Myth or Reality? | EricSilver | Tech Help | 4 | 10-03-2002 07:51 PM |
Linear Mode
