|
|
|
#1
|
|||
|
|||
Stumbles when reverse selected
Hello,
My 1989 300ce stumbles when i put it in reverse. Anybody had that problem. Ok, in drive. From what i saw in the wiring book there is a connection to the CIS that comes from the gear selector? I thought this was only when you select drive however. Any thoughts Brian |
#2
|
||||
|
||||
I remember reading about a wire on the neutral safety switch which can cause an engine stumble. I would start the car on a lift , then disconnect the wire harness form the neutral safety switch, then select reverse and see what happens. You need to put a load on the engine, the car has to be on the ground.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|