|
|
|
#1
|
||||
|
||||
Which wheel bearing grease to use
Ready to replace front rotors, pads, grease seals, and sensors. Also will be repacking the front wheel bearings. The Car: 1990 300 CE. Does MB have a special wheel bearing grease needed for this car, or is about any type of Hi-temp wheel bearing grease OK ?? I also remember hearing that there is a very small amount of grease to be left in the grease cap covering the NUT and outer bearing. Anyone have the full info on this maintenance job? Also what would you wipe off brand new rotors with before installation?? Thanks
__________________
Rich 1990 300CE 71 Chevelle SS 454 Last edited by Early Bird; 04-21-2006 at 08:15 PM. |
#2
|
||||
|
||||
Most folks use MB brand wheel bearing grease which is transluscent green. One tube is just enough for the front axle.
Wash the new rotors with dishwashing soap, rinse well then do a final wipe with brake parts cleaner when the rotors are on the spindle. Sixto |
#3
|
||||
|
||||
Try here for the procedure - http://mb.braingears.com/
All sorts of on-line info available in this thread - Service manual online: Sixto |
#4
|
||||
|
||||
Thanks man, Good info, job completed. ...
__________________
Rich 1990 300CE 71 Chevelle SS 454 |
Bookmarks |
|
|