PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Tech Help (http://www.peachparts.com/shopforum/tech-help/)
-   -   Sensotronic Brakes on '03 E320 (http://www.peachparts.com/shopforum/tech-help/156652-sensotronic-brakes-03-e320.html)

Dave M 06-22-2006 10:42 PM

Sensotronic Brakes on '03 E320
 
I tried asking for some input a couple of days ago about repalcing brake discs and pads on an '03 E320 (52,000 Mi) and received one response....thanks Matt.
Is this brake job beyond the home mechanic due to special tools and conditions? If so, how much can I expect to pay for a four wheel brake service? Any help is appreciated.

mbdoc 06-23-2006 08:20 AM

The most IMPORTANT "thing" is caution..at dealer & many independent MB shops they use scanner to turn the system OFF to replace parts & then back on...

The system must be OFF or "asleep" to replace brake parts....
BE careful!

NEVER open bleeder to depress the calipers or you WILL have to take car to dealer to have the brakes BLED!!!

Dave M 06-23-2006 12:18 PM

Thanks for responding, Doc. I was hoping you would weigh-in on this question since you are probably the most knowledgable member of this site. Unless I have the proper scan tool, I am assuming you are telling me that this new (sensotronic) brake system is going to be beyond my scope. Can you give me a ballpark idea on what to expect as far as cost on a four-wheel disc and pad replacement? Thanks again for your input.

mbdoc 06-23-2006 12:48 PM

Notice that I mentioned that by letting the system "go to sleep" you can install brake parts...Send me a PM & I will suggest how to allow the SBC system to go to sleep.

royaiii 06-23-2006 05:23 PM

There is a plug in tool that you can buy; it is made by Ate and it is called the SBS. I have attached the pdf http://www.ate.fotocentrum.de/ATE_DownloadPDF/136445.pdf and if you search the internet you will find the video showing you how to use the tool. That being said my local dealer has a special incl. SBC vehicles for brake pad change for 125. I have not been able to justify buying one of these b/c I only have 1 SBC vehicle and I have managed to just put 2000 miles over a year and a half.

I would figure 3 hours of labor + parts + bleed for changing all four brake discs and pads.

Mark M 06-24-2006 12:46 AM

I checked out the website and the video for the ATE SBS tool. Does anybody have any experience with it? How much does it cost and where can I get one?

Also, does it allow you to bleed and/or flush the brake fluid as well?


All times are GMT -4. The time now is 09:04 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website