|
|
|
#1
|
|||
|
|||
Car is a 1998 E300DT. I installed a main fuel filter which came with two o-rings. The larger one slips on the main bolt holding the filter. I can't figure out where the smaller o-ring goes. Would appreciate help. Thank you. RSL007
__________________
RSL007 1999 ML430 2001 C320 Sport 2000 SAAB 9-5 1998 E300DT 1998 C280sport 1991 300D 1991 350SDL 1982 300DT 1972 Porsche 911 Targa |
#2
|
|||
|
|||
This filter is designed for several models! The 1995 OM 606.910 engine required these for the manual shut-off bolt that screws into filter.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OM603 piston ring gap arrangement? | skleutz | Tech Help | 1 | 07-20-2004 02:15 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Diesel Discussion | 8 | 12-09-2003 12:04 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Tech Help | 6 | 12-08-2003 10:19 AM |
Injector Seal Ring Burn through Picture | Fisherman | Diesel Discussion | 19 | 03-04-2003 08:59 AM |
W126 slip ring question (560SEL) | MikeTangas | Tech Help | 1 | 01-16-2002 07:01 PM |