|
|
|
#1
|
|||
|
|||
Hello all,
I would like to know if any one has instruction/knows how to change the serpentine belt on my 93 190E 2.6L engine. I can't figure out how to take it out!! Thanks |
#2
|
|||
|
|||
Loosen the bolt by the pointer, then turn the tension
bolt by the pulley until belt is able to come off. Looking down it is the little tension assembly between the pulleys with the small wheel on it. Gary |
#3
|
|||
|
|||
AS glmoy says loosen the big bolt on the tensioner pulley assembley I think its an 18mm. Then you must loosen the top hollow bolt near the water pump to releive the tension. Now that the easy part is over. Take off the fan shroud assembly. Examine Carefully how the belt threads through the pulley system and make sure the belt diagram is still on the car or is available. Be patient, as it will take you a few attempts to get it right. I have done this a few times and start at the crankshaft and thread the belt on the power steering side first and the alternater side second. Once I have it about right pull hard on the belt to stretch it a bit and pop it over the top pulley on the alternater side. Good luck. Have some cold ones on hand for after the job is done.
__________________
1990 190E 2.6 1996 Grand Voyager 3.3 1985 Mustang GT 5.0 5 SPD 1982 Suzuki GS 750T |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to replace serpentine drive belt ? | tseinsf | Tech Help | 11 | 07-27-2007 05:40 PM |
Serpentine Belt: Designed to leave you stranded? | Ron in SC | ML, GL, G-Wagen, R-Class, Unimog, Sprinter | 7 | 08-26-2004 02:22 PM |
89' 190e Serpentine Belt Diagram | akacali | Tech Help | 1 | 05-10-2004 04:04 PM |
Alternator and serpentine belt install..Success!!! | G-Benz | Tech Help | 8 | 10-08-2001 05:13 PM |
Questions on serpentine belt on 202 (94 C280)... | hancheng | Tech Help | 5 | 08-16-2001 11:42 AM |