76 450SL no blower
I posted this question on the vintage forum, no body seems to have an answer---at least no body posted. Possible someone here can help.
The blower in the above MB does not work. The fuse is good--new. The blower motor is not frozen. I suspect the switch, it may be a rhostate--I'm not sure. How can this unit be pulled.and can it be rebuilt as I've not found a replacement on the net. Thanks Terry |
Blower motor
1 Attachment(s)
I believe the blower motor assembly can be removed by taking the cover off that is located on top of the firewall right between (and in front of) the wiper arms. Directly behind the air cleaner assembly.
|
Gary, I've pulled the cover and checked the motor. The problem is that I can't see how the switch on the consol is mounted and I need to get it out to check it. Then the question is weather it can be repaired or not. Can't seem to find a new one.
Thanks Terry |
motor
Are you talking about the switch above the radio or the knob on the heater panel. Either way, I have one.
|
450sl blower
just grab on and pull it's held by a spring clip.then you will see large skinny nut undo nut and it should be out of there.there were two types,one that had a wiring pigtail[which i think is yours] and one without.from that switch the power goes to the resistor pack which is in the front right area of the fan housing good luck.
|
ENGR--the knob is below the radio--above the a/c knob--that panel has me buffaloed on how to remove. are ther screws above the ash tray holding it?
Dave P--Thanks, if I can get the switch out I can inspect and hopefully repair ENGR if the switch is bad and cannot be repaired, I'll contact you. Hey thanks both for the comeback. This site is great if ya got an old MB. Terry |
heater panel
1 Attachment(s)
Yes, the screws by the ashtray hold the heater panel in place. Be careful when you pull the panel away from the console, one of the switches has a thin tube connected to the back of it. I assume it has a gas charge in it for temperature control. It is very small diameter and will break easily. Of course this is the one that is broken on my parts car. See the picture attached.
Good luck. |
Thanks ENGR, I'm going to tear( bad term)into it next week. Just now UPS brought the parts I need to get the engine running properly. ie. NO MISS.
Thanks again Terry |
All times are GMT -4. The time now is 12:01 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website