|
|
|
|
|
#1
04-12-2001, 05:40 PM
|
|||
|
|||
|
I had 2 cylinders heads rebuilted and I am in process of reinstall them back to the engine of my 380 SE. I run into problem of setting valves timing,align timing mark of the crank and camshaft.I'm sure appreciated if anyone can show me how to do this. 
|
|
#2
04-12-2001, 08:03 PM
|
|||
|
|||
|
Make the crank mark line up with o (TDC). Turn both cams so that the key is lined up with the mark on the thrust washer and it is lined up with the mark on the cam stand.
keep all of the slack out of the chain on the drivers side of the engine and slide on the chain. install the tensioner next and rotate the engine by hand and recheck timing...if it is off, just move it a tooth.
__________________
Benzmac: Donnie Drummonds ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 11 YRS
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1985 500 SEL Ign Timing | bfgw | Tech Help | 0 | 01-03-2005 04:32 PM |
| 1985 380SL Timing Chain Noise Question? | ezrider | Tech Help | 4 | 09-29-2003 04:58 PM |
| timing chain degree allowance- 1985 380 sl | a2aa | Tech Help | 16 | 11-12-2002 11:20 PM |
| 1985 380 timing chain? | Jason Beal | Tech Help | 1 | 07-28-2002 06:18 PM |
| Replace Timing Chain?? When?? | Gregg Vurbeff | Diesel Discussion | 13 | 01-24-2002 02:03 PM |
Linear Mode
