|
|
|
#1
|
|||
|
|||
i just changed the signal switch and the wiper motor. Now the horn doesn't work and the intermitten wiper speed doesn't perform a full rotation,it makesone sweep then everyone after that is either 1/4 or 1/2 a swipe. The other speeds work fine. Any suggestions?
[Edited by rich30769 on 04-18-2001 at 06:26 PM]
__________________
Richie 1986 300E |
#2
|
|||
|
|||
Did you remove horn contact from the old switch to new switch ???...when your install new wiper motor be careful both motor & linkage must in parking (rested)position.
__________________
MB STARS Master Guild Technician,17 years MB tech 14 years independent shop owner |
#3
|
|||
|
|||
wiper motor
Yes.It was in the rested position. Actually, the only reason changed he motor in the first place was because the oiginal switch was bad and the wiper started to act this way. after I changed the turn signal/wiper switch, the wiper was acting the same way. In regards to the horn contact, since you just mentioned it I probably made a big mistake and didn't change it. Of course I threw the original switch away. I guess I'm screwed now! Thanks for the reply though. If you know how I can get a contact PLEASE,PLEASE let me know. TIA!!!
__________________
Richie 1986 300E |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebadging '87 300e | emr0591 | Detailing and Interior | 6 | 09-04-2007 09:12 AM |
'86 300E vs '91 300E... Any opinions out there??? | pjtib | Tech Help | 23 | 05-04-2005 09:26 PM |
300E FIRST-gear start | brewtoo | Tech Help | 16 | 03-11-2005 05:27 PM |
please help... car horn not working! | Badinfo | Tech Help | 12 | 04-27-2002 08:48 AM |
Transmission Question 1988 300E (Need Technical help)n | china beach | Tech Help | 4 | 03-26-2002 10:25 AM |