When I was changing my oil, I decided to pull off the passenger front (R. Front) wheel, to see if I could find the metallic clanking noise that I have been hearing for quite some time. Sure enough, the noise was coming from the shock absorber and, the Guide Rod. Now, I know that guide rod replacement is a real bear, but I was wondering, is it even possible for a DIYer to consider doing it himself? Also, as far as the shocks, will Gabriels do, or do I have to get Bilstein in order to have them on for more than 3 months.
Thanks, and God Bless,
Dave.

__________________
Currently Driving:
1986 Mercedes Benz 560SEL
1994 Lincoln Town Car
1994 Cadillac Deville
1985 Lincoln Town Car- Retired

The Official Car of a Realtor- Lincoln Town Car
The Official Car of the Successful Independent Insurance Agent- Mercedes Benz S Class

Replacing guide rod mounts is tedious in a rust free car. I can only imagine the headache in a car that's seen salt.

If the looseness is confined to the rear mount then the trickiest part is moving the wheel forward to get the new mount in place. You can use a come-along to pull the lower control arm forward or deflate the tire and use a jack between the wheel and fender. Spread the load along the fender liner so you don't damage anything. It doesn't take much force to move the wheel forward with the guide rod mount loose.

If there's looseness in the front attachment, the sring has to come off to remove the lower perch to get to the front bushings. Use only a spring compressor designed for MBs.

Everything to be said about shock selection has been said :/

Sixto
93 300SE 3.0