|
|
|
|
|
#1
05-27-2001, 11:44 AM
|
|||
|
|||
|
Hi All, I was replacing my three prong temperature switch (close to the thermostat) and when I turned it I broke off the top of the "thermostat vacuum valve"(unit with two vacuum lines coming from the top of it). Now the car does not run very good..it will sputter out as soon as I step on the gas. Does anyone have any experience with this item? Any way I can bypass it until I can get the part?
Thanks in advance! Charles
__________________
1987 300D 
|
|
#3
05-27-2001, 05:40 PM
|
|||
|
|||
|
I plugged off both ends. The car will idle fine but when I step on the gas it sputters and dies out..is this caused by the thermo vacuum valve or should I look for something else?
TIA Charles
__________________
1987 300D
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SLS Valve in 190E 2.3-16v defective ??? | mercedes16valve | Tech Help | 5 | 11-05-2004 09:17 PM |
| 190E idle control valve | stewart42 | Tech Help | 3 | 07-08-2004 02:52 PM |
| Idle Control Valve - 88' 190e 2.3L | gards | Tech Help | 1 | 07-29-2003 12:55 PM |
| 190E 2.3 Idle Control Valve | Doug McCutchan | Tech Help | 2 | 01-03-2002 08:45 PM |
| M103 Valve guides | edbardzik | Tech Help | 3 | 06-01-2000 07:37 AM |
Linear Mode
