|
|
|
|
|
#1
05-28-2001, 06:36 PM
|
|||
|
|||
|
Can someone please tell me how to remove the two center vent housing on my 83' 300D. The formed rubber housing which directs the AC air is not attached and cold air blow out the side wall.
|
|
#2
05-28-2001, 09:09 PM
|
|||
|
|||
|
I presume that your car is of w123 designation. if so, remove the bottom dashboard covers, insert your hand behind the air con vents from behind the dash, grab the stem of the circular vent and twist, it should pop out easily.
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Center Vents = No Air and Cold Air from Rear Vent | Lance Allison | Tech Help | 6 | 08-21-2009 09:23 AM |
| Center vents problem | Steve300 | Diesel Discussion | 24 | 08-11-2005 06:35 AM |
| flapping noise and little output from center heat vents (87 300e) | dirtysocks | Tech Help | 2 | 01-30-2004 10:16 PM |
| Center vents not blowing hard in 300E | mike690003 | Tech Help | 7 | 10-23-2003 01:17 AM |
| Bowden Cables on 126 Center Vents | gidpor | Tech Help | 0 | 12-25-2001 02:59 AM |
Linear Mode
