|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
On my 1991 126, the rod that transfers torque from the motor drive side of the passenger seatback sheared at the square face insert.
I removed it and continued to use the seat while waiting to get a new rod. Just got the rod in. After I get inside the seat back again, is there a motor centering, justification or alignment process to align the two sides of the seat back so they start at the same relative position? George Stephenson george.stephenson@trw.com |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY Bearing Bracket guide rod mount replacement for Mercedes Benz 300SD. | whunter | Diesel Discussion | 53 | 09-23-2019 11:59 AM |
Procedure for Replacing Neutral Safety Switch on 126 Chassis | downeyjc | Tech Help | 2 | 06-20-2008 01:47 AM |