|
|
|
#1
|
||||
|
||||
Does anyone know if the "Y" rubber vacuum connector on the valve cover of a 240D automatic is supposed to have some sort of pin hole restrictor in it.
After adjusting my valves for the first time in 75K (See post in Diesel Discussion), I noticed that the "Y" connector seemed to have a blockage. So I used a coat hanger to push it out. It is a little cyclinder with a pin hole in the middle,and it fits tightly into the rubber. Unfortunately, I don't remember which "leg" it came out of. Can anyone help? Joe |
#2
|
||||
|
||||
I would suggest trying to put it back or replacing the connector with one that has the restriction orifice. If you look at the "electrical troubleshooting manual" for this vehicle it shows the restriction orifice in the appropriate places. It was there for a reason.
__________________
Jim |
#3
|
||||
|
||||
It's only a $3 part. I think I would just get a new one.
__________________
Palangi 2004 C240 Wagon 203.261 Baby Benz 2008 ML320 CDI Highway Cruiser 2006 Toyota Prius, Saving the Planet @ 48 mpg 2000 F-150, Destroying the Planet @ 20 mpg TRUMP .......... WHITEHOUSE HILLARY .........JAILHOUSE BERNIE .......... NUTHOUSE 0BAMA .......... OUTHOUSE |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rubber parts: pingpong between glass shop, MB parts, body shop | ktlimq | Tech Help | 5 | 06-20-2004 07:45 AM |
Vaccum questions 73 280 SEL | MikeTangas | Tech Help | 5 | 04-07-2000 10:35 PM |