|
|
|
#1
|
|||
|
|||
crank position sensor
I have a 1987 260E MB and I need to replace the Position sensor and I would really appreciate if someone can show me where this sensor is located?
Thank you, Tati |
#2
|
||||
|
||||
why do you need to replace it? it is located near the oil filter on the engine block, the connector runs along the engine wiring harness over to the ezl (ignition control module) on the drivers side fender there are two sensors available depending on engine number, send me your vin and i can tell you precisely which one you need
__________________
1967 250 S 1967 280SE 1968 250S 1971 280 SE 1973 220 1974 280 S 1975 450 SEL 1976 220 D 1979 300SD 1983 300 SD 1985 230 TE euro 1986 280SL 1986 500 SEL euro 1986 190E 2.3 1990 300 SE 2003 C230 K 2004 C230 K 1987 560SEL 1987 300SDL now in canada 2005 C230 1998 C43 AMG Sold to DON 1993 190E 2.6 300TD Former daily driver Totaled current: R320 CDI Ram 2500 Cummins |
#3
|
|||
|
|||
cranck position sensor
My vin number is WDBEA26D4HA459349 I already have the part from MB Part number A 002 153 90 28.
Thank you, Tati |
#4
|
|||
|
|||
CPS is kinda a pain. Its in a spot on the back of the engine by the bell housing and its tough to get at. Its held in by a 5mm (im almost positive) hex head. Your best bet is to get the car up high and get at it from underneath. The reason its hard is that you can't really get more than a hand up there to pull it out, which depending on how long yours has been in there, it could be covered w/ gunk and tough. In the end, I just had my benz mechanic take care of it.
__________________
87 300E 202k on the clock |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|