Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 07-27-2001, 10:05 PM
Registered User
 
Join Date: Jul 2001
Posts: 74
I have a 1987 190 European spec model. A/C control panel is different than US models. I work in Kuwait and A/C is a life or death matter. The A/C performance is almost adequate now for summer temps in Kuwait(after system flush and compressor, drier and expansion valve change) but have some little things that just bug me. My temperature slider control does not affect the temperature of cold air from the vents(it has never worked since I have had the car) What is this slider actually supposed to do to the system to change the temperatue of the air. I noticed in the wiring conduit that goes to the A/C clutch that there are 2 wires that have been cut in the past and are not connected to anything. I have a wiring schematic but no luck finding these wires. When I turn the blower up to 3 or 4 the temperature of the air becomes much warmer. When I have to sit at a light for over a couple of minutes the temperature of the air rises dramatically, this has always been a problem but not as bad as it was before the recent maintenance.
Reply With Quote
  #2  
Old 07-28-2001, 12:38 AM
Moderator
 
Join Date: Mar 2000
Location: Gainesville FL
Posts: 6,844
I am only remotely familiar with the manual controls (only Tempmatic in US). I think it is like a thermostat. It will change the cycling temperature. This will have absolutely no affect on your system if it doesn't cool well enough to cycle.

Be sure that the recirculate door is workin properly as it will raise the duct temp by 10deg F if it isn't.
__________________
Steve Brotherton
Continental Imports
Gainesville FL
Bosch Master, ASE Master, L1
33 years MB technician
Reply With Quote
  #3  
Old 07-28-2001, 06:10 AM
Registered User
 
Join Date: Jul 2001
Posts: 74
There is a pink valve behind the A/C console. What is is supposed to do? Does this control the flapper?
Reply With Quote
  #4  
Old 07-31-2001, 05:18 PM
Registered User
 
Join Date: Jul 2001
Posts: 74
I just found another problem by accident. The A/C compressor runs anytime(even with heater selected) the blower speed switch is in any postion other than off.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
1992 MB 300 SE A/C Problems Ralph-Andree Tech Help 2 07-22-2004 07:48 PM
300E A/C problems Speedtek Tech Help 3 04-29-2003 12:57 AM
A/C & heater problems on 400 SE sread Tech Help 2 11-27-2002 02:30 PM
A/C overhaul in 97 C230--Advice/Help needed rpmillie Tech Help 4 06-26-2002 01:42 PM
190E 2.6 A/C problems arnelrac Tech Help 1 02-23-2002 10:14 PM



All times are GMT -4. The time now is 03:04 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page