OIL Pan Torque settings - and Gasket goop?
Anyone know the torque settings on the lower oil pan bolts on a 4.2LV8 (400E)? I need to replace the gasket and don't want to over tighten the pan. Do you use any gasket sealer or just put it on dry?
Tks BOBB |
Do a search for the torque numbers and if the pan is not bent and not overtightened you will not need any sealant. You do not want to use sealant on the tranny pan.
|
I use a short 1/4" drive ratchet. This way you have controll over how much torque you put to it. Just watch the gasket and you will see if it is pushing out. If so, back off a little.
I have had the best results with doing pans and soforth by feel alone. |
The torque value should be 10NM. However, Benzmac is correct in using the small ratchet and feel. The use of a torque wrench is difficult unless the vehicle is up high on a lift.
|
Last time I tried using the factory 7-8 NM torque setting, I split the gasket in 3 different places, not sure if the gasket material is inferior or if the pan is not level in those areas?
I think Benzmac may have the answer due to his lengthy experience replacing gasket. |
Gasket torque
Thanks for all the good advice. Do you use any gasket sealer or just put it on dry:confused: Tks > BOBB
|
Lower Oil Pan Gasket (4.2L V8)
Gasket $18 - Will post pictures when I do the next oil change and replace the pan gasket. Mechanic says to install dry - no gasket sealer > BOBB;)
|
All times are GMT -4. The time now is 06:31 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website