|
|
|
#1
|
|||
|
|||
300TE Start-up Roughness
Hi All:
Some time back, I inquired of roughness at idle, and on your recommendation replaced my motor mounts. Now the car is very smooth. Thanks! I have a start-up question for you. When I start my '92 after sitting for more than a few hours, it seems to sputter quite a bit and often stalls. After a re-start it sputters again, but after 5-10 seconds runs very smoothly. Does not act this way when the engine is warm. Any thoughts? Thanks in advance for the help! Chris |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hard to start 300TE | cdp3456 | Tech Help | 2 | 06-30-2004 09:32 AM |
car won't start | jude | Tech Help | 5 | 06-03-2004 11:24 AM |
Sequence to start a M104 | atamians | Tech Help | 1 | 01-17-2003 04:26 PM |
1991 420SEL - beginning of a cold start problem | DieselGuy | Tech Help | 1 | 07-30-2001 03:56 AM |
Using oil in 300TE 4 matic-Where to start | nasedo67 | Tech Help | 1 | 11-27-2000 05:33 PM |