|
|
|
#1
|
||||
|
||||
93 300e-2.8 how much oil
i was surprised at the DIY section and the topsider technique. i already have the motorized jcwhitney siphon so i'm all set to do my first oil change. already have my MB filter but still don't have a manual, so can someone fill me in on the oil capacity?
TIA Last edited by jsmith; 09-09-2001 at 06:38 PM. |
#2
|
|||
|
|||
8 quarts
|
#3
|
||||
|
||||
Yes, Stan is right, 7.9 quarts.
Some sources say that it holds 7.4 quarts, but it's 7.9. So 8 is fine, but check it (when warm) before you dump the 8th quart in because you don't want to overfill the crankcase, that can lead to problems!
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#4
|
|||
|
|||
Whoa!! is the 2.8 eight cylinders?
|
#5
|
||||
|
||||
Joel,
Are you drunk!? I'm just playing. Please reread and then 'reiterate' what you are trying to say! But it is the 2.8 liter 6 cylinder engine.
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#6
|
|||
|
|||
i know it is 6 cylinders!! so why 8, my 3.0 only takes
6 liters (6.3 US quarts)! educate me, please! |
#7
|
||||
|
||||
The book on my 6 cylinder - E320 says 7.9 quarts but if you do a filter and oil change and put 7.9 quarts it is going be overfilled. It takes 6.5 quarts to get it in the middle of the marks on the dipstick.
__________________
Jim |
#8
|
||||
|
||||
i figured if i picked up a couple of the gallon castrol gtx containers i would be ok. turns out just barely...
thanks everyone Last edited by jsmith; 09-07-2001 at 07:24 AM. |
#9
|
||||
|
||||
i did an oil and filter change using my jcwhitney "topsider" and have dumped 7 quarts in and it just barely clears the plastic at the "min" mark so i guess it really is 7.9 on the w124 with the 104 engine - at least on my '93 2.8 it is. i'm gonna check it again tomorrow once i get it outside...
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil Change DIY Instructions | Limited Edition | Off-Topic Discussion | 5 | 09-23-2007 10:56 AM |
300E 2.8 M104 engine oil pan | radunegru | Tech Help | 0 | 08-09-2004 05:06 PM |
oil filter removal tool for '91 300E? | bd37703 | Tech Help | 6 | 07-16-2003 11:05 AM |