Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #16  
Old 10-01-2008, 10:47 PM
Registered User
 
Join Date: Mar 2006
Location: Australia
Posts: 115
Or perhaps buy the brand new original Bosch MAF from ******** for $177?

If it doesn't solve the problem, sell the MAF on eBay for $200.

PS. When you fit a new MAF, disconnect the battery for about 30 minutes to reset the engine computer settings to factory default.

Then, fit the new MAF and run the car for about 10 minutes at idle until it is running smoothly. Take the car for a run increasing RPM until maximum is achieved. This will allow the engine computer adapt the settings to the new MAF.

Reply With Quote
  #17  
Old 10-02-2008, 02:48 PM
Registered User
 
Join Date: Jan 2002
Posts: 157
Removed and Cleaned the MAF today, car runs properly so far, but since the issue was intermittent to begin with, I'll have to give it a couple of days to be sure.

In the Process of trying to find the MAF, I made a few observations which could explain the issue.

1. There is a lot of oil in the air intake system, in virtually every hose, in the airbox, all over the MAF. The source of this oil seems to be the small hose leading to the airbox, which later connects to the top of the dip stick tube.

2. The oil has destroyed one corner of the airfilter and a small amount of unflitered air has probably been getting in.

3. The engine oil is way overfilled, by what looks like a Hyundai dealer based on the sticker.
Reply With Quote
  #18  
Old 10-02-2008, 03:32 PM
Registered User
 
Join Date: Feb 2004
Location: Walnut Creek, CA & 1,150 miles S of Key West
Posts: 4,874
Oil should be checked at operating temp, within a few minutes after shutting down. If you are checking it stone cold it is probably NOT overfilled.

You may need to clean the oil from the air box and runner leading to the MAF too.
__________________
Terry Allison
N. Calif. & Boca Chica, Panama

09' E320 Bluetec 77k (USA)
09' Hyundai Santa Fe Diesel 48k (S.A.)
Reply With Quote
  #19  
Old 10-02-2008, 09:41 PM
Registered User
 
Join Date: Mar 2006
Location: Australia
Posts: 115
Oil must NOT be overfilled. Otherwise the crankshaft will beat the oil into a froth. The oil pump CANNOT pump froth or aerated oil. That means an oil overfilled engine will suffer from the LACK of lubrication.

You must immediately drain some oil from your engine to protect the engine and stop your new MAF from being destroyed. Buy a simple oil drain suction pump from your local autobits store (drains via the dipstick tube).

Quote:
The source of this oil seems to be the small hose leading to the airbox, which later connects to the top of the dip stick tube.
What the #$%@???
Reply With Quote
  #20  
Old 10-03-2008, 10:49 AM
Registered User
 
Join Date: Sep 2006
Posts: 106
If the oil is not overfilled, then I am suspecting you might have an issue in the crankcase ventilation system (that tube is part of the system). Check the valves, tubes, oil separator (I think this thread is about a c230k that has one of these), etc. When these are not working right, you can get the oil in the air filter, on the MAF, etc.
Reply With Quote
  #21  
Old 10-04-2008, 08:02 PM
Registered User
 
Join Date: Jan 2002
Posts: 157
The oil is DEFINATELY WAY overfilled (Of course I checked it hot).

Oil is being changed on monday, in the meantime, I am driving the Volvo.

I just wonder if this could actually be the source of the oil in the system?

Diagnosing the Crankcase ventilation system seems beyond my abilities, so I will clean all the hoses after the oil change, observe, and hope for the best.
Reply With Quote
  #22  
Old 10-24-2008, 06:57 AM
Registered User
 
Join Date: Jan 2002
Posts: 157
Just a quick update. Its been 3 weeks now since I cleaned the MAF with CRC Sensor Cleaner, and I have had no problems whatsoever. I have driven about 3 -4k km since that time, so I feel pretty confident in saying that the issue is resolved.

Still getting oil in the system, but thats a separate issue.
Reply With Quote
  #23  
Old 10-24-2008, 09:12 AM
Registered User
 
Join Date: Sep 2004
Location: DFW / Collin County Texas
Posts: 1,882
Glad to hear the CRC worked for you. It didn't work for me, but then I wasn't exactly experiencing massive oil contamination like you were. Perhaps my MAF was indeed defective and on its way out...

__________________
08 W251 R350
97 W210 E320
91 W124 300E
86 W126 560SEL
85 W126 380SE Silver
85 W126 380SE Cranberry
79 W123 250
78 W123 280E
75 W114 280
Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 08:29 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page