300E power seat help
 

hello, i have a 1989 mercedes 300e (w124) and the driver seat has a function that doesnt work. The function that raises and lowers the back part of the seat you sit on. I can hear the motor turning when i press the button however it doesnt raise/lower the seat, please help thanks

If you can hear the motor...
 

Something is disengaged in the seat. The only way to find out is by removing the seat and see.

i think its the gear spinning around in the motor, the gear shaft is squared and over time it becomes round so im guessing thats what im hearing, how to you take out the shaft, is it press fitted or do i have to unscrew the hex bolts?

I had the same issue. The worm gear on the cable had come out of the gears in the box. I took it apart and put it back in and put some grease on it. It has worked now for over a year. I'll see if I can find a picture. You will need to remove the seat or at least take the seat cover off.

Yes you need to unscrew the hex bolts.

Sounds good although ran into a problem
 

Wow thanks a lot for that reply, and perfect pic as well. But i got myself a pretty annoying problem. I managed to get the first 2 bolts out no problem. Then the back left one was pretty rusted but came out. BUT the back right one is so rusted that it striped, and i don't mean the head. It just keeps spinning around. I tried prying the bolt and turning at the same time and no go. I tried for about a good hour. I'm limited to equipment so how do i go about taking this bolt out, any suggestions from anyone please

Can you pry it out by using the cover? If not can you cut the head off with a dremel? If it spins it may just pull out.

I hate rust!

alright ill give it another shot, but im gonna ask my questions now so ill know what to do. The motor thats spinning but not working is for the front height adjustment, right now its as low as it can go so i have no room to work under there. How many bolts are there to take the seat off the rails and what position should the seat be in to make things easier based on your experience. Also once i got the rail in front of me, i gotta take the two hex bolts out from the motor side but what about the other side of the gear shaft, is that one pressed in? Or is there bolts too, because the way the seat sits now i cant see it. And finally how much do the gear shafts run in price?

oh my mistake, i reread your post and from what i understand you fixed your problem without replacing anything, hopefully i will be able to do the same

I believe there are 5 bolts in all. 4 in the seat base, 2 front and 2 rear and the bolt hold the black track in the center of the car. Power the seat all the way forward and remove the back bolts. Then power it all the way back and remove the front bolts. Then unplug the power to the seat. In my wagon I take the back seat base out and remove the front seat from the back. The sedan may or may not work like that.

I fixed mine by opening the small box that the cable goes into, not the end that is in the motor. You may or may not have the same issue. I thought I took pictures of the inside workings, but I can't seem to find them.