|
|
|
|
|
#1
10-25-2001, 03:01 PM
|
|||
|
|||
560SEL valve seals
I am ready to replace my valve seals. I get smoke at startup and at acceleration after the car is warm. I also have several fouled spark plugs from oil. I am assuming it is a valve seal problem.
Does anyone have any helpful hints on replacing the valve seals? Or a drawing that shows the assembly? I will be pressurizing the cylinder with air through the spark plug hole to keep the valve from dropping in.
__________________
David 1988 560SEL, Green, Chrome wheels. 2000 Suburban, 20" wheels, DVD, wood grain dash (wife's car). 67 Beetle euro, Lots of Empi parts. 69 Beetle conv, 1980s cal look. 
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OM 603 delivery valve seals cure rough idle? | Zeitgeist | Diesel Discussion | 11 | 12-21-2003 11:52 PM |
| valve seals and new problems | hihosilver | Tech Help | 0 | 10-12-2003 10:01 PM |
| Valve Stem Seals Tool | rs899 | Diesel Discussion | 5 | 06-12-2003 11:38 PM |
| Valve Stem Seals Sucessfully Replaced | John Plut | Tech Help | 21 | 04-18-2002 11:08 AM |
| unsteady valve clearances | jerryrigged | Diesel Discussion | 5 | 01-24-2002 09:55 PM |
Linear Mode
