|
|
|
#1
|
|||
|
|||
SLS question 124 wagon
My SLS level controller works fine when I un-hook it from the connecting rod. I raise the lever and the rear of the car goes up. I lower the lever and the rear of the car comes back down. The ride is normal not bouncy or harsh.
My problem occurs when I connect the rod and put weight in the car. It does not raise up. I ordered a new connecting rod and installed it today. I still have the same issue. I think the bracket that holds the upper rod to the torsion bar has slipped down (see pictures). Does anyone have a picture of the proper placement of that upper bracket? I've read and reread Section 32-0501 of the FSM and everything seems to be working as designed. Anyone have any other ideas?
__________________
1987 300TD 309, xxx 2.8.2014 10,000 mile OCI Be careful of the toes you step on today, as they may be connected to the ass you have to kiss tomorrow. anonymous “Be who you are and say what you feel, because those who mind don’t matter, and those who matter won’t mind.” Dr. Seuss Last edited by Bio300TDTdriver; 06-28-2009 at 10:07 PM. Reason: Because Vbulliten is LAME and HTML code doesn't work |
#2
|
|||
|
|||
I think you are correct. There is a flat spot on the anti-sway bar that one leg of the "U" bolt rests against. It appears from your picture that this is currently not the case. Mark
|
#3
|
|||
|
|||
Quote:
Chris
__________________
1987 300TD 309, xxx 2.8.2014 10,000 mile OCI Be careful of the toes you step on today, as they may be connected to the ass you have to kiss tomorrow. anonymous “Be who you are and say what you feel, because those who mind don’t matter, and those who matter won’t mind.” Dr. Seuss |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|